SW5190902_O&M Agreement_20191114

Operation & Maintenance Agreement
Project Name:
Project Location:
CaptiveAire Expansion
305 Northbrook Drive, Youngsville, NC
Maintenance records shall be kept on the following BMP(s). This maintenance recora snail De Kepi
deficient BMP elements noted in the inspection will be corrected, repaired, or replaced immediately
integrity of structures, safety of the public, and the pollutant removal efficiency of the BMP(s).
The BMP(s) on this project include {check all that apply & corresl
Bioretention Cell Quantity:
Dry Detention Basin Quantity:
Grassed Swale Quantity:
Green Roof
Quantity:
Infiltration Basin
Quantity:
Infiltration Trench
Quantity:
Level SpreaderNFS
Quantity:
Permeable Pavement
Quantity:
Proprietary System
Quantity:
Rainwater Harvesting
Quantity:
Sand Filter
Quantity:
Stormwater Wetland
Quantity:
Wet Detention Basin
Quantity:
Disconnected Impervious Area
Present:
User Defined BMP
Present:
Jing
O&M tables will be adi
Location(s):
Location(s):
Location(s):
Location(s):
Location(s):
Location(s):
Location(s):
Location(s):
Location(s):
Location(s):
Location(s):
1
Location(s):
0
Location(s):
No
Location(s):
No
Location(s):
in a log in a known set location. Any
. These deficiencies can affect the
led automats
ISouth End of Property I
l acknowledge and agree by my signature below that I am responsible for the performance of the maintenance procedures listed for each
BMP above, and attached O&M tables. I agree to notify NCDENR of any problems with the system or prior to any changes to the system or
responsible party.
Signature:
Responsible Party:
Title & Organization:
Street address:
City, state, zip:
Phone number(s):
Email:
Brandon Hafner
CAS Youngsville, LLC
4641 Paragon Park Road
Raleigh, NC 27616
919-882-2410
brandon.hafner@captivea ire cam
Date:
.4 a Notary Public for the State of AD/\r2—
,�7
County of r do hearby certify that
personally appeared before me this r -1< day of-Q.Y�I�yPl" e and
acknowledge the due execution of the Op lions an"d Mai rite na ace Agreement .
Witness my hand and official seal,
.oOOJjffly/'
My commission expires
STORM-EZ 9126/19
Version 1.4 O&M Manual Page 1 of 3

.
#ormuvater , et art .. aintenance Requtrernents
Important maintenance procedures:
Immediately following construction of the stormwater wetland, bi-weekly inspections will be conducted and wetland
plants will be watered bi-weekly until vegetation becomes established (commonly six weeks).
No portion of the stormwater wetland will be fertilized after the first initial fertilization that is required to establish the
wetland plants.
- Stable groundcover will be maintained in the drainage area to reduce the sediment load to the wetland.
Once a year, a dam safety expert should inspect the embankment.
After the stormwater wetland is established, it shall be inspected monthly and within 24 hours after every storm event greater than 1.0
inches (or 1.5 inches if in a Coastal County). Records of operation and maintenance will be kept in a known set location and will be
available upon request.
Inspection activities shall be performed as follows. Any problems that are found shall be repaired immediately.
BMP element:
Potential problem_
How I will remediate the problem:
Entire BMP
Trash/debris is present.
Remove the trash/debris.
The perimeter of the BMP
Areas of bare soil and/or
Regrade the soil if necessary to remove the gully, and then plant a ground
erosive gullies have formed.
cover and water until it is established. Provide lime and a one-time fertilizer
application.
Vegetation is too short or too
Maintain vegetation at a height of approximately six inches.
long.
Forebay
Sediment has accumulated in
Search for the source of the sediment and remedy the problem if possible.
the forebay to a depth that
Remove the sediment and dispose of it in a location where it will not cause
inhibits the forebay from
impacts to streams or the BMP.
Erosion has occurred.
Provide additional erosion protection such as reinforced turf matting or
riprap if needed to prevent future erosion problems.
Weeds are present.
Remove the weeds, preferably by hand. If a pesticide is used, wipe it on
the plants rather than spraying.
The inlet device
The pipe is clogged.
Unclog the pipe. Dispose of the sediment off -site.
The pipe is cracked or
Replace the pipe.
otherwise damaged.
Erosion is occurring in the
Regrade the Swale if necessary to smooth it over and provide erosion
swale.
control devices such as reinforced turf matting or riprap to avoid future
problems with erosion.
Stone verge is clogged or
Remove sediment and replace with clean stone.
covered in sediment (if
applicable).
STORM-EZ 9126119
Version 1.4 O&M Manual Page 2 of 3

7777Lo-. equirenents attmueIrR.
Deep pool, shallow water and
Algal growth covers over 50% of
Consult a professional to remove and control the algal growth.
shallow land areas
the deep pool and shallow
water areas.
Cattails, phragmites or other
Remove invasives by physical removal or by wiping them with pesticide (do
invasive plants cover 50% of the
not spray) — consult a professional.
deep pool and shallow water
Shallow land remains flooded
Unclog the outlet device immediately,
more than 5 days after a storm
event.
Plants are dead, diseased or
Determine the source of the problem: soils, hydrology, disease, etc.
dying.
Remedy the problem and replace plants. Provide a one-time fertilizer
application to establish the ground cover if necessary.
Best professional practices
Prune according to best professional practices.
show that pruning is needed to
maintain optimal plant health.
Sediment has accumulated and
Search for the source of the sediment and remedy the problem if possible.
reduced the depth to 75% of the
Remove the sediment and dispose of it in a location where it will not cause
original design depth of the
impacts to streams or the BMP.
Embankment
A tree has started to grow on the
Consult a dam safety specialist to remove the tree.
embankment.
An annual inspection by
Make all needed repairs,
appropriate professional shows
that the embankment needs
Evidence of muskrat or beaver
Consult a professional to remove muskrats or beavers.
activity is present.
Micropool
Sediment has accumulated and
Search for the source of the sediment and remedy the problem if possible.
reduced the depth to 75% of the
Remove the sediment and dispose of it in a location where it will not cause
original design depth.
impacts to streams or the BMP.
The outlet device
Clogging has occurred.
Clean out the outlet device. Dispose of the sediment off -site.
The outlet device is damaged
Repair or replace the outlet device.
The receiving water
Erosion or other signs of
Contact the local NC Department of Environment and Natural Resources
damage have occurred at the
Regional Office.
outlet.
STORM-EZ 9/26119
Version 1.4 O&M Manual Page 3 of 3