HomeMy WebLinkAbout19960457 Ver 1_Scoping Comments_20080401O?O? W A T?9oG
c
o -c
1996 o +5'7
Michael F. Easley, Governor
William G. Ross Jr., Secretary
North Carolina Department of Environment and Natural Resources
Coleen Sullins, Director
Division of Water Quality
April 1, 2008
MEMORANDUM
To: Melba McGee, Environmental Coordinator, DENR
From: Amy Euliss, NC Division of Water Quality, Winston-Salem Regional Office
Subject: Scoping comments on proposed improvements to SR 1514 (Bamboo Road, 0.72 miles) in
Watauga County, State Project No. 11C.095033.
Reference your correspondence dated March 7, 2008 in which you requested comments for the referenced
project. Preliminary analysis of the project reveals the potential for multiple impacts to perennial streams
and jurisdictional wetlands in the project area. More specifically, impacts to:
Stream Name River Basin Stream
Classifications Stream Index
Number
Days Creek New River WSIV; Tr:+ 10-1-3-4
East Fork South Fork
New River New River WSIV; Tr:+ 10-1-3-(1)
Further investigations at a higher resolution should be undertaken. to verify the presence of other streams
and/or jurisdictional wetlands in the area. In the event that any jurisdictional areas are identified, the
Division of Water Quality requests that NCDOT consider the following environmental issues for the
proposed project:
Project Specific Comments:
1. If Any Class Tr:
Days Creek and East Fork South Fork New River are class IV;Tr:+ waters of the State. DWQ
recommends that the most protective sediment and erosion control BMPs be implemented to reduce
the risk of turbidity violations in trout waters. In addition, all disturbances within trout buffers shall
be conducted in accordance with NC Division of Land Resources and NC Wildlife Resources
Commission requirements.
General Project Comments:
1. The environmental document shall provide a detailed and itemized presentation of the proposed
impacts to wetlands and streams with corresponding mapping. If mitigation is necessary as
required by 15A NCAC 2H.0506(h), it is preferable to present a conceptual (if not finalized)
Transportation Permitting Unit
1650 Mail Service Center, Raleigh, North Carolina 27699-1650
2321 Crabtree Boulevard, Suite 250, Raleigh, North Carolina 27604
Phone: 919-733-1786 / FAX 919-733-6893 / Internet: http://h2o.enr.state.nc.us/ncwetiands
None Carolin
Atom illy
An Equal Opportunity/Affirmative Action Employer - 50% Recycled/10% Post Consumer Paper
i
mitigation plan with the environmental documentation. Appropriate mitigation plans will be
required prior to issuance of a 401 Water Quality Certification.
2. Environmental assessment alternatives shall consider design criteria that reduce the impacts to
streams and wetlands from storm water runoff. These alternatives shall include road designs that
allow for treatment of the storm water runoff through best management practices as detailed in
the most recent version of NC DWQ Stormwater Best Management Practices, such as grassed
swales, buffer areas, preformed scour holes, retention basins, etc.
After the selection of the preferred alternative and prior to an issuance of the 401 Water Quality
Certification, the NCDOT is respectfully reminded that they will need to demonstrate the
avoidance and minimization of impacts to wetlands (and streams) to the maximum extent
practical. In accordance with the Environmental Management Commission's Rules {I 5A NCAC
2H.0506(h)), mitigation will be required for impacts of greater than 1 acre to wetlands. In the
event that mitigation is required, the mitigation plan shall be designed to replace appropriate lost
functions and values. The NC Ecosystem Enhancement Program may be available for use as
wetland mitigation.
4. In accordance with the Environmental Management Commission's Rules ( 15A NCAC
2H.0506(h)), mitigation will be required for impacts of greater than 150 linear feet to any single
perennial stream. In the event that mitigation is required, the mitigation plan shall be designed to
replace appropriate lost functions and values. The NC Ecosystem Enhancement Program may be
available for use as stream mitigation.
5. DWQ is very concerned with sediment and erosion impacts that could result from this project.
NC DOT shall address these concerns by describing the potential impacts that may occur to the
aquatic environments and any mitigating factors that would reduce the impacts.
6. If concrete is used during construction, a dry work area shall be maintained to prevent direct
contact between curing concrete and stream water. Water that inadvertently contacts uncured
concrete shall not be discharged to surface waters due to the potential for elevated pH and
possible aquatic life and fish kills.
7. If temporary access roads or detours are constructed, the site shall be graded to its preconstruction
contours and elevations. Disturbed areas shall be seeded or mulched to stabilize the soil and
appropriate native woody species should be planted. When using temporary structures the area
shall be cleared but not grubbed. Clearing the area with chain saws, mowers, bush-hogs, or other
mechanized equipment and leaving the stumps and root mat intact allows the area to re-vegetate
naturally and minimizes soil disturbance.
Placement of culverts and other structures in waters, streams, and wetlands shall be below the
elevation of the streambed by one foot for all culverts with a diameter greater than 48 inches, and
20 percent of the culvert diameter for culverts having a diameter less than 48 inches, to allow low
flow passage of water and aquatic life. Design and placement of culverts and other structures
including temporary erosion control measures shall not be conducted in a manner that may result
in dis-equilibrium of wetlands or streambeds or banks, adjacent to or upstream and down stream
of the above structures. The applicant is required to provide evidence that the equilibrium is being
maintained if requested in writing by DWQ. If this condition is unable to be met due to bedrock
or other limiting features encountered during construction, please contact the NC DWQ for
guidance on how to proceed and to determine whether or not a permit modification will be
required.
9. If multiple pipes or barrels are required, they shall be designed to mimic natural stream cross
section as closely as possible including pipes or barrels at flood plain elevation and/or sills where
appropriate. Widening the stream channel shall be avoided. Stream channel widening at the inlet
or outlet end of structures typically decreases water velocity causing sediment deposition that
requires increased maintenance and disrupts aquatic life passage.
10. Sediment and erosion control measures sufficient to protect water resources must be implemented
and maintained in accordance with the most recent version of North Carolina Sediment and
Erosion Control Planning and Design Manual and the most recent version of NCS000250.
11. All work in or adjacent to stream waters shall be conducted in a dry work area unless otherwise
approved by NC DWQ. Approved BMP measures from the most current version of NCDOT
Construction and Maintenance Activities manual such as sandbags, rock berms, cofferdams and
other diversion structures should be used to prevent excavation in flowing water.
12. Sediment and erosion control measures shall not be placed in wetlands and streams.
13. Borrow/waste areas shall avoid wetlands to the maximum extent practical. Impacts to wetlands
in borrow/waste areas could precipitate compensatory mitigation.
14. While the use of National Wetland Inventory (NWI) maps, NC Coastal Region Evaluation of
Wetland Significance (NC-CREWS) maps and soil survey maps are useful tools, their inherent
inaccuracies require that qualified personnel perform onsite wetland delineations prior to permit
approval.
15. Heavy equipment shall be operated from the bank rather than in stream channels in order to
minimize sedimentation and reduce the likelihood of introducing other pollutants into streams
This equipment shall be inspected daily and maintained to prevent contamination of surface
waters from leaking fuels, lubricants, hydraulic fluids, or other toxic materials.
16. In most cases, the DWQ prefers the replacement of the existing structure at the same location
with road closure. If road closure is not feasible, a temporary detour should be designed and
located to avoid wetland impacts, minimize the need for clearing and to avoid destabilizing
stream banks. If the structure will be on a new alignment, the old structure shall be removed and
the approach fills removed from the 100-year floodplain. Approach fills should be removed and
restored to the natural ground elevation. The area shall be stabilized with grass and planted with
native tree species. Tall fescue shall not be used in riparian areas.
17. Riprap shall not be placed in the active thalweg channel or placed in the streambed in a manner
that precludes aquatic life passage. Bioengineering boulders or structures should be properly
designed, sized and installed.
Thank you for requesting our input at this time. The DOT is reminded that issuance of a 401 Water
Quality Certification requires that appropriate measures be instituted to ensure that water quality
standards are met and designated uses are not degraded or lost. If you have any questions or require
additional information, please contact Amy Euliss at (336) 771-4959.
cc: Monte Matthews, US Army Corps of Engineers, Raleigh Field Office
Federal Highway Administration '
Mike Pettyjohn, PE, Division 11 Engineer
Heath Slaughter, Division 11 Environmental Officer
Suzette Moiling, Blue Ridge Parkway
Ron Linville, NC Wildlife Resources Commission
DWQ 401/Wetlands Transportation Group
File Copy