Stanly_Well Abandonment_20230807 (9)

WELL ABANDONMENT RECORD For Internal Use ONLY:
1.Well Contractor Information: WELL ABANDONMENT DETAILS
i G�7 .4?/l ( .t"/�i h-� z ✓� 7a.For Geoprobe/DPT or Closed-Loop Geothermal Wells having the same
Well Contractor Name(or well owner personally abandoning well on his/her property) well construction/depth,only I GW-30 is needed. Indicate TOTAL NUMBER of
2— v �q wells abandoned:
NC Well Contractor Certification Numb/erQ' 7b.Approximate volume of water remaining in well(s): (gal.)
( S-1-5'C/-LC Q y']//'s FOR WATER SUPPLY WELLS ONLY:
Company Name r j
7c.Type of disinfectant used: L• (��}-
2.Well Construction Permit#: A Ur rl O��v
List all applicable well construction permits(i.e.UIC,County,State,Variance,etc.)iflmown V 2
7d.Amount of disinfectant used:
3.Well use(check well use): •• : i ;. ;-�f-,',.i
Water Supply Well: 7e.Sealing materials used(check all that apply):
❑Agricultural ❑Municipal/Public f�.INeat Cement Grout ❑Bentonite Chips or Pellets
❑Geothermal(Heating/Cooling Supply) ❑Residential Water Supply(single) ❑ Sand Cement Grout ❑Dry Clay
❑ludustrial/Commercial ❑Residential Water Supply(shared) ❑ Concrete Grout ❑Drill Cuttings
_Olrri ation _ ❑ Specialty Grout ❑ Gravel
Non-Water Supply Well: El Slurry ❑ Other(explain under 7g)
onitoring ❑Recovery
Injection Well: 7E For each material selected above,provide amount of materials used:
El Aquifer Recharge ❑Groundwater Remediation
❑Aquifer Storage and Recovery ❑Salinity Barrier
❑Aquifer Test ❑Stormwater Drainage
❑Experimental Technology El Subsidence Control
7g.Provide a brief description of the abandonment procedure:
❑Geothermal(Closed Loop) ❑Tracer
❑Geothermal(Heating/Cooling Return) []Other(explain under 7g) ��;�: O e7T�` /�J Pi[ /C7 ��✓7 o1i�?�
4.Date well(s)abandoned:
CZ,/mil
5a.Well location:
Facility/Owner Name,= Facility ID#(ifapplicable)�// 8.Certification:Phy
il Address,City,and Zip Signature of Certified Well Contractor or Well Owner Date
0 "1 By signing this form,1 hereby cert6 that the well(s) was(were) abandoned in
County Parcel Identification No.(PIN) accordance with 1 SA NCAC 02C.0100 or 2C.0200 Well Construction Standards
Sb.Latitude and longitude in degrees/minutes/seconds or decimal degrees: and that a copy of this record has b een provided to the well owner.
(if well field,one lat/lang is sufficient) 9.Site diagram or additional well details:
N W You may use the back of this page to provide additional well site details or well
abandonment details. You may also attach additional pages if necessary.
CONSTRUCTION DETAILS OF WELLS)BEING ABANDONED SUBMITTAL INSTRUCTIONS
Attach well construction record(s)ifavailable.For multiple injection or non-water supply wells
ONLY with the same constructionlabandonment,you can submit one form.
10a. For All Wells: Submit this form within 30 days of completion of well
6a.Well ID#: �f�� ���. abandonment to the following:
Division of Water Resources,Information Processing Unit,
6b.Total well depth: (ft) 1617 Mail Service Center,Raleigh,NC 27699-1617
10b.For Iniection Wells: In addition to sending the forth to the address in 10a
6c.Borehole diameter: (in.) above, also submit one copy of this form within 30 days of completion of well
abandonment to the following:
6d.Water level below ground surface: x (ft.) Division of Water Resources,Underground Injection Control Program,
-7 1636 Mail Service Center,Raleigh,NC 27699-1636
6e.Outer casing length(if known): C_ (ft.) 10c.For Water Supply&Iniection Wells: In addition to sending the form to the
address(es)above,also submit one copy of this form within 30 days of completion
40
,, / of well abandonment to the county health department of the county where
6f.Inner casing/tubing length Of known):14- 14 (ft.) abandoned.
6g.Screen length(if known): (fL)
Form GW-30 North Carolina Department of Environmental Quality-Division of Water Resources Revised 2-22-2016