Mecklenburg_Well Abandonment_20230602 (7)

WELL ABANDONMENT RECO" For Internal Use ONLY:
1.Well Contractor Inffoo`rmation: / WELL ABANDONMENT DETAILS
7a.For Geoprobe/DPT or Closed-Loop Geothermal Wells having the same
Well Contractor Name(or well owner personally abandoning well on his/her property) well construction/depth,only I GW-30 is needed. Indicate TOTAL NUMBER of
_, 2 a P A wells abandoned:
NC Well Contractor Certification Number 7b.Approximate volume of water remaining in well(s): (gal.)
—A e" l /� 41/ /1��:' FOR WATER SUPPLY WELLS ONLY:
Company Name 0 f�
7a Type of disinfectant used: (
2.Well Construction Permit#:
List all applicable well construction permits(i.e.UIC,County,State,Variance,etc.)if/mown
7d.Amount of disinfectant used:
3.Well use(check well use):
Water Supply Well: 7e.Sealing materials used(check all that apply):
❑Agricultural ❑Municipal/Public ❑Neat Cement Grout 0,9entonite Chips or Pellets
❑Geothermal(FIeating/Cooling Supply) ❑Residential Water Supply(single) ❑ Sand Cement Grout ❑Dry Clay
❑Industrial/Commercial ❑Residential Water Supply(shared) ❑ Concrete Grout ❑ Drill Cuttings
❑Irri ation ❑ Specialty Grout ❑ Gravel
Nop ater Supply Well: ❑Bentonite Slurry ❑ Other(explain under 7g)
[ Monitoring ❑Recovery
Injection Well: 7f.For each material selected above,provide amount of materials used:
IiAquifer Recharge El Groundwater Remediation
❑Aquifer Storage and Recovery ❑Salinity Barrier ! T ILL
❑Aquifer Test ❑Stormwater Drainage
❑Experimental Technology ❑Subsidence Control
7g.Provide a brief description of the abandonment procedure:
❑Geothermal(Closed Loop) ❑Tracer } r
❑Geothermal (Heating/Cooling Return) ❑Other(explain under 7
4.Date well(s)abandoned: S-4 -tip 3
5a Well location:
Facility/Owner Name Facility ID#(if applicably 8.Cer'[cation:
Physr Addddressss�,City and Zip 1 A r"'t 6 Signature of ed Well Contractor or Well Owner Date
`z ` `�/\6J ,� tyd/ I By signing this form, I hereby certify that the well(s) was (were)abandoned in
County Parcel Identification No.(PIN) accordance with 15A NCAC 02C.0100 or 2C.0200 Well Construction Standards
and that a copy of this record has been provided to the well owner.
5b.Latitude and longitude In degrees/minutes/seconds or decimal degrees:
(if well field�gtne 1 t/lo g is s crent) V io 9.Site diagram or additional well details:
of! Dig Pb F 1 �/ W You may use the back of this page to provide additional well site details or well
�f abandonment details. You may also attach additional pages if necessary.
CONSTRUCTION DETAILS OF WELL(S)BEING ABANDONED SUBMITTAL INSTRUCTIONS
Attach well construction record(s)ifavailable.For multiple injection or non-watersupply wells
ONLY with the same constr
uction/abandonment,you can submit oneform. 10a. For All Wells: Submit this form within 30 days of completion of well
6a.Well ID#• f abandonment to the following:
Division of Water Resources,Information Processing Unit,
6b.Total well depth: (ft.) 1617 Mail Service Center,Raleigh,NC 27699-1617
i 10b.For Iniection Wells: In addition to sending the form to the address in l0a
6c.Borehole diameter: (in.) above, also submit one copy of this form within 30 days of completion of well
abandonment to the following:
p r
6d.Water level below ground surface / (ft.) Division of Water Resources,Underground Injection Control Program,
1636 Mail Service Center,Raleigh,NC 27699-1636
i i
6e.Outer casing length(if known): ` (ft,) 10c.For Water Supply&Iniection Wells: In addition to sending the form to the
address(es)above,also submit one copy of this form within 30 days of completion
of well abandonment to the county health department of the county where
6E Inner casing/tubing length(if known): (ft,) abandoned.
6g.Screen length(if known): 00
Form GW-30 North Carolina Department of Environmental Quality-Division of Water Resources Revised 2-22-2016