NCG210183_G&G Forest Products Sampling_20220114

A
.Y��
P',A
NCDENR
Stormwater Discharge Outfall (SDO)
Qualitative Monitoring Report
For guidance on filling out this form, please visit. httl2:1/12ortal.ncdenr.org/web/wq/ws/su/npdessw#tab-4
Permit No.: N/C/6
Facility Name:
County: Wired 1 i
Inspector:
Date of Inspection:
Time of Inspection:
L /D/ G//� orertificate of Coverage No.: N/C/G,c�?/
Total Event Precipitation (inches):
ne No.
Was this a "Representative Storm Event" or "Measureable Storm Event" as defined by the permit?
(See information below.)
[(,'es ❑ No
Please verify whether Qualitative Monitoring must be performed during a "representative storm
event" or "measureable storm event" (requirements vary, depending on the permit).
Qualitative monitoring requirements vary. Most permits require qualitative monitoring to be
performed during a "representative storm event" or during a "measureable storm event." However,
some permits do not have this requirement. Please refer to these definitions, if applicable.
A "representative storm event" is a storm event that measures greater than 0.1 inches of rainfall
and that is preceded by at least 72 hours (3 days) in which no storm event measuring greater than
0.1 inches has occurred. A single storm event may contain up to 10 consecutive hours of no
precipitation.
A "measurable storm event" is a storm event that results in an actual discharge from the
permitted site outfall. The previous measurable storm event must have been at least 72 hours
prior. The 72-hour storm interval does not apply if the permittee is able to document that a shorter
interval is representative for local storm events during the sampling period, and the permittee
obtains approval from the local DWQ Regional Office.
By thi"ignature, I certify that this report is accurate and complete to the best of my knowledge:
re of Permi6ee or Designee)
Pagel of 2
SWU-242, Last modified 10/25/2012

1. Outfall Description:
Outfall No. Structure (pipe, ditch, etc.) °
Receiving Stream:
Describe the industrial activities that occur within the outfall drainage area:
2. Color: Describe the color of the discharge using basic colors (red, brown, blue, etc.) and tint
(light, medium, dark) as descriptors: 4 C�
3. Odor: Describe any distinct odors that the discharge may have (i.e., smells strongly of oil,
weak chlorine odor, etc.):
4. Clarity: Choose the number which best describes the clarity of the discharge, where 1 is
clear and 5 is very cloudy:
1 /2> 3 4 5
5. Floating Solids: Choose the number which best describes the amount of floating solids in
the stormwater discharge, where 1 is no solids and 5 is the surface covered with floating solids:
1 2' 3 4 5
6. Suspended Solids: Choose the number which best describes the amount of suspended
solids in the stormwater discharge, where 1 is no solids and 5 is extremely muddy:
1 6 3 4 5
7. Is there any foam in the stormwater discharge? Yes No
B. Is there an oil sheen in the stormwater discharge? Yes
9. Is there evidence of erosion or deposition at the outfall? Ye No
■ 10. Other Obvious Indicators of Stormwater Pollution:
List and describe
Note: Low clarity, high solids, and/or the presence of foam, oil sheen, or erosion/deposition
may be indicative of pollutant exposure. These conditions warrant further investigation.
Page 2 of 2
SWU-242, Last modified 10/25/2012

1. Outfall Description:
Outfall No. 2— Structure (pipe, ditch, etc.)
T
Receiving Stream:
Describe the industrial activities that occur within the outfall drainage area:
2. Color: Describe the color of the discharge using basic colors (red, brown, blue, etc.) and tint
(light, medium, dark) as descriptors:
1_
3. Odor: Describe any distinct odors that the discharge may have (i.e., smells strongly of oil,
weak chlorine odor, etc.):
4. Clarity: Choose the number which best describes the clarity of the discharge, where 1 is
clear and 5 is very cloudy: ```-�'�
1 U 3 4 5
! S. Floating Solids: Choose the number which best describes the amount of floating solids in
the stormwater discharge, where 1 is no solids and 5 is the surface covered with floating solids:
I ,
�11 2 3 4 5
6. Suspended Solids: Choose the number which best describes the amount of suspended
solids in the stormwater discharge, where 1 is no solids and 5 is extremely muddy:
1 2 3 4 5
7. Is there any foam in the stormwater discharge? Yes No
S. Is there an oil sheen in the stormwater discharge? Yes No
9. Is there evidence of erosion or deposition at the outfall? Yes No
10. Other Obvious Indicators of Stormwater Pollution:
List and describe
Note: Low clarity, high solids, and/or the presence of foam, oil sheen, or erosion/deposition
may be indicative of pollutant exposure. These conditions warrant further investigation.
Page 2 of 2
SWU-242, Last modified 10/25/2012

1. Outfall Description:
Outfall No. Structure (pipe, ditch, etc.) E�
Receiving Stream:
Describe the industrial activities that occur within the outfall drainage area:
2. Color: Describe the color of the discharge using basic colors (red, brown, blue, etc.) and tint
(light, medium, dark) as descriptors:
1_
3. Odor: Describe any distinct odors that the discharge may have (i.e., smells strongly of oil,
weak chlorine odor, etc.):
4. Clarity: Choose the number which best describes the clarity of the discharge, where 1 is
�. clear and 5 is very cloudy:
1 2 3 4 5
I5. Floating Solids: Choose the number which best describes the amount of floating solids in
the stormwater discharge, where 1 is no solids and 5 is the surface covered with floating solids:
1 2 3 4 5
C�
6. Suspended Solids: Choose the number which best describes the amount of suspended
solids in the stormwater discharge, where 1 is no solids and 5 is extremely muddy:
1 2 3 4 5
7. Is there any foam in the stormwater discharge? Yes allo'
8. Is there an oil sheen in the stormwater discharge? Yes
9. Is there evidence of erosion or deposition at the outfall? Yes No
10. Other Obvious Indicators of Stormwater Pollution:
List and describe
Note: Low clarity, high solids, and/or the presence of foam, oil sheen, or erosion/deposition
may be indicative of pollutant exposure. These conditions warrant further investigation.
Page 2 of 2
SWU-242, Last modified 10/25/2012

z
O
H
Q
J
>
W
W
U
-a
_Q
�
--�
a
c
s
CL
a_
cc
a
U
rL
U)
w
J
C)
o
S
S
z°
j
co
z
Z
c
o
Q
Q
C-
m
f0 a
Q c
N
}CD
VO
_
D
(D
U
-5 E
o
z
O
c
ro E o
N
U m m
N
�
00
m E u °
m
� u m ?
.00
d a
N
C
w
v
ti m c0i> 3
�
�
O
o
a
C
N E
(D 0) OL
l�
_.
a
3 L N
—°
E c
15 E CD
c E m o`0
0 c 0) u
J m m m
O1
=
N
O
N
p
s
0
U
c
N
c
o
�
E
N
06
Q
E
0
°
O
O
LL
N
a
C7
m
C7
a
(n
O
n
C0
.2
cu
'D
O
O N
U +7+
d C N
- U) 0
U

SEMI-ANNUAL ROUTINE VISUAL INSPECTION
Date:
Inspectors):
Area(s) Inspected:
Lumber Storage
!/
Trash Dumpsters
Loading operations
General plant site
t/
Dust house
1/
Fuel storage tanks
Maintenance Shop
V
Other (specify)
I�
Were any problems found?
Yes DNo
If yes, describe:
Steps taken to correct problem:
S' ed nsp cto s)):
(Insert into Appendix F)

C FOREST PRODUCTS
UNION GROVE, NC 28689
PH: 704-539-5110 FAX: [phone]
D----.
Date: October 26, 2021 J�
To: Employees ?p '
From: Brandon
Re: Safety Meeting
Please acknowledge below that the monthly safety meeting was held today, October 26, 2021.
❖ No cell phone use except for breaks & lunch.
❖ Give your supervisor or Brandon a three (3) day notice if you are going to be out of work.
Shirt-tails must be tucked in at all times.
Work boots are required to be worn on site.
No smoking at work station. Smoking permitted only during breaks and lunch and only
above the wooden fence at the office.
❖ Everyone must punch their time card, no hand written time.
Storm Water Prevention
Personal Protection required: Ear Plugs
Eye Safety Glasses in required areas.
Use handrails to prevent trip/fall hazard.
Welding Shields
No headphone or music during work hours
Machine/Equipment Safety:
&®rn ' �
z,64 I V '4?ije.,
Verify lock out -tag out.
Forklift Safety
Check Machines Daily
K' a ;7� ( n-e
XA v OTC
Z