SW4210901_Deed Restriction/Protective Covenant Form_20211117

Low Density Residential Subdivisions
Deed Restrictions & Protective Covenances
In accordance with Title 15 NCAC 2H.1000 and S.L. 2006-246, the Stormwater Management
Regulations, deed restrictions and protective covenants are required for Low Density Residential
Subdivisions where lots will be subdivided and sold. Deed restrictions and protective covenants are
necessary to ensure that the development maintains a "built -upon" area consistent with the applicable
regulation governing the density level.
I, _Kevin D. Sasser_ acknowledge and affirm by my signature below, that I will cause the following deed
restrictions and protective covenants to be recorded for _Kernodle Landing Phase 2_ prior to the sale of
any lot:
1. The following covenants are intended to ensure ongoing compliance with State Stormwater
Management Permit Number , as issued by the Division of Energy, Mineral and
Land Resources under the Stormwater Management Regulations.
2. The State of North Carolina is made a beneficiary of these covenants to the extent necessary to
maintain compliance with the stormwater management permit.
3. These covenants are to run with the land and be binding on all persons and parties claiming
under them.
4. The covenants pertaining to stormwater may not be altered or rescinded without the express
written consent of the State of North Carolina, Division of Energy, Mineral and Land Resources.
5. Alteration of the drainage as shown on the approved plan may not take place without the
concurrence of the Division of Energy, Mineral and Land Resources.
6. The maximum allowable built -upon area per lot is _See Attached square feet. This allotted
amount includes any built -upon area constructed within the lot property boundaries, and that
portion of the right-of-way between the front lot line and the edge of the pavement. Built upon area
includes, but is not limited to, structures, asphalt, concrete, gravel, brick, stone, slate, and
coquina, but does not include raised, open wood decking, or the water surface of swimming pools.
7. In the case of a lot within CAMA's regulated AEC, where the Division of Coastal Management
calculates a different maximum allowable built -upon area for that lot than is shown herein, the
governing maximum built -upon area for that lot shall be the most restrictive of the two.
8. Filling in or plping of any vegetative conveyances (ditches, swales, etc.) associated with the
development except for average driveway crossings is strictly prohibited by any persons.
9. Each lot will maintain a 30* foot wide vegetated buffer between all impervious areas and surface
waters.
10. All roof drains shall terminate at least 30* foot from the mean high watermark of surface waters.
*50 foot for projects located in the 20 coastal counties.
Signature
I, 1 ,
E, H" L:-�,l i�_jl
a Notary Public in the
State of N , County of Cam, t L L
do hereby certify thatpersonally appeared
before me this the l a, day of 01) , 20j-4 , and acknowledge
the due execution of the foregoing instrument. Witness my hand and official seal,
Signature �_4== M Nao Public
Rndp
CountyMy Commission expires TA. aa_
_
Form DRPC-5 Rev.2 05Nov2009 Page 1 of 1 %gypQ
C A R
l`dL� �`��\

Kernodle Landing, Phase 2
Alamance County
Impervious Area Lot Allocation
Lot Number
Lot Area (SF)
% Total Area
Allowable
BUA/Lot le
29
30,777
1.93%
7,070
30
30,000
1.88%
7,000
31
32,737
2.05%
7,520
32
30,000
1.88%
7,000
33
36,192
2.26%
8,314
34
30,003
1.88%
7,000
35
30,000
1.88%
7,000
36
30,000
1.88%
7,000
37
31,543
1.97%
7,246
38
31,172
1.95%
7,161
39
30,817
1.93%
7,079
40
36,928
2.31%
8,483
41
53,595
3.35%
12,312
42
349,480
21.86%
79,742
44
38,956
2.44%
8,949
45
34,091
2.13%
7,832
46
39,245
2.46%
9,015
47
36,064
2.26%
8,285
48
34,670
2.17%
7,965
49
34,800
2.18%
7,994
50
34,800
2.18%
7,994
51
35,360
2.21%
8,123
52
31,870
1.99%
7,321
53
35,750
2.24%
8,213
54
184,977
11.57%
42,493
55
116,547
7.29%
26,773
56
58,636
3.67%
13,470
96
32,745
2.05%
7,522
97
32,885
2.06% 1
7,554
98
33,893
2.12% 1
7,786
Totals 1,598,534 100.00% 367,216
BUA = Built -Upon Area