NCG030519_DMR_Dec_2019_20200220

Prysmian
Group
February 20, 2020
Storm Water Permitting Unit
Division of Energy, Mineral, and Land Resources
Attention: Bradley Bennett
1612 Mail Service Center
Raleigh, NC 27699-1612
Re: Storm Water Discharge Monitoring Report
Draka Elevator, Inc.
6809 Corporation Parkway
Battleboro, NC 27809
Certificate of Coverage NCG030519
Dear Sir/Madam:
PRYSMIAN
Draka
Q General Cable
Enclosed are two copies of the Storm Water Discharge Outfall (SDO) Monitoring Report for the Draka Elevator,
Inc. Distribution Center facility located at 6809 Corporation Parkway, Battleboro, Nash County, North Carolina.
This sampling event represents a Tiered response monitoring event with samples collected in December 2019.
Zinc was not detected above the BMV at DC001, however the DC-BG001 background sampling location showed
a concentration of 0.12 mg/L of zinc. This indicates that the stormwater flowing onto the property has a higher
concentration of zinc than the runoff produced by the site. Tiered monitoring will continue at both DC001 and
DC-BG001 for zinc monthly until three consecutive sample results are below the benchmark values or are within
benchmark range.
In accordance with Part II, Section B of the general permit, Draka Elevator, Inc. will conduct tiered monitoring
during the next qualifying rain event. If you have any questions or concerns, please feel free to contact me at
[phone], or our environmental consultant, Rob Duffy of Antea Group at [phone].
Sincerely,
Y�4�
Wynne Ellis
Global Director of Operations
Draka Elevator, Inc.
Attachments
Draka Elevator Products, Inc.
2151 North Church Street
Rocky Mount, NC 27804
Tel. [phone]
www.prysmiangroup.com

Semi-annual Stormwater Discharge Monitoring Report
for North Carolina Division of Water Quality General Permit No. NCG030000
Date submitted February 19, 2020
CERTIFICATE OF COVERAGE NO. NCG03 0 5 1 9
FACILITY NAME Draka Elevator, Inc. - Distribution Center
COUNTY Nash
PERSON COLLECTING SAMPLES Charles Dickens III
LABORATORY Waypoint Analytical Lab Cert. # 402
Comments on sample collection or analysis:
Part A: Stormwater Benchmarks and Monitoring Results
SAMPLE COLLECTION YEAR 2019
SAMPLE PERIOD ❑ Jan -June ❑ July -Dec
or 0 Monthly' December (month)
DISCHARGING TO CLASS ❑ORW ❑HQW ❑Trout ❑PNA
❑Zero -flow ❑Water Supply ❑SA
❑Other
PLEASE REMEMBER TO SIGN ON PAGES 2 AND/OR 3 4
n No discharge this period?'
Outfall No.
Date Sample
Collected'
(mo/dd/yr)
24-hour rainfall
amount,
Inches3
Total Suspended Solids
pH
Standard units
Copper
Lead
Zinc
Non -Polar O&G/
Total Petroleum
Hydrocarbons
Total Toxic
Organics'
Benchmarks ===>
-
-
100 mg/L or 50 mg/L4
6.0 — 9.0
0.007 mg/L
0.03 mg/L
0.067 mg/L
15 mg/L
1 mg/L
DC-OF001
12/17/19
0.11
<0.020
<0.050
DC-BG001
12/17/19
0.11
0.12
' Monthly sampling (instead of semi-annual) must begin with the second consecutive benchmark exceedance for the same parameter at the same outfall.
z For sampling periods with no discharge at any single outfall, you must still submit this discharge monitoring report with a checkmark here.
3The total precipitation must be recorded using data from an on -site rain gauge. Unattended sites may be eligible for a waiver of the rain gauge requirement.
° See General Permit, Table 3 identifying the especially sensitive receiving water classifications where the more protective benchmark applies.
s Total Toxic Organics sampling is applicable only for those facilities which perform metal finishing operations, manufacture semiconductors, manufacture
electronic crystals, or manufacture cathode ray tubes. For purposes of this permit the definition of Total Toxic Organics is that definition contained in the EPA
Effluent Guidelines for the facility subject to the requirement to sample (for metal finishing use the definition as found in 40 CFR 433.11; for semiconductor
manufacture use the definition as found in 40 CFR 469.12; for electronic crystal manufacture use the definition as found in 40 CFR 469.22; and for cathode ray
tube manufacture use the definition found in 40 CFR 469.31).
Permit Date: 11/1/2012-10/31/2017 SWU-245, last revised 10/25/2012
Page 1 of 3

Facilities that incorporate a solvent management plan into the Stormwater Pollution Prevention Plan may so certify, and the requirement for TTO monitoring
may be waived. The solvent management plan shall include a list of the total toxic organic compounds used and the other elements listed in the General
Permit. For those facilities electing to employ the TTO monitoring waiver, the discharger shall sign the following certification statement:
"Based upon my inquiry of the person or persons directly responsible for managing compliance with the permit monitoring requirement for total toxic organics
(TTO), 1 certify that to the best of my knowledge and belief, no dumping of concentrated toxic organics into the stormwater or areas which are exposed to rainfall or
Stormwater runoff has occurred since filing the last discharge monitoring report. I further certify that this facility is implementing the all the provisions of the
solvent management plan included in the Stormwater Pollution Prevention Plan."
Wynne Ellis
Name (Print name)
Global Director of Operations
Title (Print tie)
02/20/2020
(Sig ure) (Date)
Note: Results must be reported in numerical format. Do not report Below Detection Limit, BDL, <PQL, Non -detect, ND, or other similar non -numerical
format. When results are below the applicable limits, they must be reported in the format, "<XX mg/L", where XX is the numerical value of the detection
limit, reporting limit, etc. in mg/L.
Note: if you report a sample value in excess of the benchmark, you must implement Tier 1, Tier 2, or Tier 3 responses. See General Permit text.
Part B: Vehicle Maintenance Area Monitoring Results: only for facilities averaging > 55 gal of new oil per month. N/A
❑X No discharge this period?Z
Outfall No.
Date Sample
Collected'
(mo/dd/yr)
24-hour rainfall
amount,
3
Inches
Non -polar O&G/TPH by
EPA 1664 (SGT-HEM)
Total Suspended Solids
pH
Benchmarks =__>
_
15 mg/L
100 mg/L or 50 mg/L*
6.0 — 9.0 SU
Footnotes from Part A also apply to this Part B
* See General Permit text, Table 5, identifying the especially sensitive receiving water classifications where the more protective benchmark applies.
Permit Date: 11/1/2012-10/31/2017 SWU-245, last revised 10/25/2012
Page 2 of 3

Note: If you report a sample value in excess of the benchmark, you must implement Tier 1, Tier 2, or Tier 3 responses. See General Permit text.
FOR PART A AND PART B MONITORING RESULTS:
• A BENCHMARK EXCEEDANCE TRIGGERS TIER 1 REQUIREMENTS. SEE PERMIT PART II SECTION B.
• 2 EXCEEDANCES IN A ROW FOR THE SAME PARAMETER AT THE SAME OUTFALL TRIGGER TIER 2 REQUIREMENTS, SEE PERMIT PART II SECTION B.
• TIER 3: HAS YOUR FACILITY HAD 4 OR MORE BENCHMARK EXCEEDENCES FOR THE SAME PARAMETER AT ANY ONE OUTFALL? YES [,X NO ❑
IF YES, HAVE YOU CONTACTED THE DWQ REGIONAL OFFICE? YES 50 NO ❑
REGIONAL OFFICE CONTACT NAME:
Mail an original and one copy of this DMR including all "No Discharge" reports within 30 days of receipt of the lab results (or at end of monitoring period
in the case of "No Discharge" reports) to:
Division of Water Quality
Attn: DWQ Central Files
1617 Mail Service Center
Raleigh, North Carolina 27699-1617
YOU MUST SIGN THIS CERTIFICATION FOR ANY INFORMATION REPORTED:
"I certify, under penalty of law, that this document and all attachments were prepared under my direction or supervision in accordance with a system designed to
assure that qualified personnel properly gather and evaluate the information submitted. Based on my inquiry of the person or persons who manage the system, or
those persons directly responsible for gathering the information, the information submitted is, to the best of my knowledge and belief, true, accurate, and complete. I
am aware that there are significant penalties for submitting false information, including the possibility of fines and imprisonment for knowing violations."
(Signature of
02/20/2020
(Date)
Permit Date: 11/1/2012-10/31/2017 SWU-245, last revised 10/25/2012
Page 3 of 3