SW3200601_01_SpeedwaySubstation_StormwaterLowDensityApplication_SIGNED_20200720

Permit No.
(to be provided by DEMLR)
State of North Carol! na
Department of Environment and Natural Resources
Division of Energy, Mineral and Land Resources
STORMWATER MANAGEMENT PERMIT APPLICATION FORM
LOW D EN SI TY SU PPLEM EN T
This form may be photompi6d for use as an original
A low density project is one that meets the appropriate criteria for built upon area and transports stormwater
runoff primarily through vegetated conveyances. Low density projects should not have a discrete stormwater
collection system as defined by 15A NCAC 2H .1002(18). Low density requirements and density factors can be
found in Session Law 2008-211, 15A NCAC 2H .1000, Session Law 2006-246 and the State of North Carolina
Stormwater Best Management Practice Manual. Curb and gutter systems are allowed provided they meet the
requirements in 15A NCAC 2H .1008(g).
I. PROJECT INFORMATION
Project Name : Speedway Substation
Contact Person: Jennifer Kirby Phone Number: ( 856 )357-5006
Number of Lots:1 Allowable Built Upon Area (BUA) Per Lot*:36%
Number of Dwelling Units Per Acre**:N/A%
Low Density Development (check one): ® without curb & gutter ❑ with curb & gutter, outlets to (check one):
❑ Swales ❑ Vegetated Area
*If lot sizes are not uniform, attach a table indicating the number of lots, lot sizes and allowable built upon area for each lot.
The attachment must include the project name, phase, page numbers and provide area subtotals and totals. BUA shall be
shown in units of square feet.
**(Phase Ii Post -Construction [non -SA] only)
II. BUILT UPON AREA
Refer to DEMLR's forms and applications website for specific language that must be recorded in the deed
restrictions for all subdivided projects. (http://portal.ncdenr.ora/web/lr/state-stonnwater-forms_docs)
Complete the following calculation in the space provided below where:
• SA Site Area - the total project area above Mean High Water.
• DF Density Factor - the appropriate percent built upon area divided by 100.
• RA Road Area - the total impervious surface occupied by roadways.
• OA Other Area - the total area of impervious surfaces such as clubhouses, tennis courts, sidewalks, etc.
• No. of Lots - the total number of lots in the subdivision.
• BUA per Lot - the computed allowable built upon area for each lot including driveways and impervious
surfaces located between the front lot line and the edge of pavement.
• Total allowable lot BUA - the computed allowable built upon area for all lots combined.
• Total BUA from lot listing - the sum of built upon area allocated for each lot on the list of non -uniform lots.
Calculation:
Form SW401-Low Density-Rev.3-2/10/09 Page 1 of 4

For uniform lot sizes:
(SA: ft2 x DF: )^(RA: ft2) — (OA: ft2) = BUA per Lot = ft2
(No of Lots: )
For non -uniform lot sizes:
a. (SA: ft2 x DF: ) — (RA: ft') (OA: ft2) = Total allowable lot BUA = ft2
b. Total BUA from lot listing: sf. b must be < a
III. DESIGN INFORMATION
Complete the following table. If additional space is needed the information should be provided in the same
format as Table 1 and attached to this form. Rainfall intensity data can be found in Appendix 8.03 of the State
of North Carolina Erosion and Sediment Control Planning and Design Manual or at
http://hdsc.nws.noaa.gov/hdsc/Pfds/
Table 1. Swale design information based on the 10-vear storm.
Swale No.
Drainage
Area (ac)
Impervious
Area (ac)
Grassed
Area (ac)
C
Q
(cfs)
Slope
(%)
Vallow
s
Vactual
(fps)
Flow
Depth ft
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
IV. REQUIRED ITEMS CHECKLIST
Form SW401-Low Density-Rev.3-2/10/09 Page 2 of 4

The following checklist outlines design requirements per the North Carolina Administrative Code Section 15A
NCAC 2H .1000, NCDENR BMP Manual (2007), Session Law 2006-246, and Session Law 2008-211.
Please indicate the page or plan sheet numbers where the supporting documentation can be found. An
incomplete submittal package will result in a request for additional information. This will delay final
review and approval of the project. Initial in the space provided to indicate that the following requirements
have been met and supporting documentation is provided as necessary. If the applicant has designated an agent
on the Stormwater Management Permit Application Form, the agent may initial below. If any item is not met,
then justification must be attached. Only complete items n through p for projects with curb outlets.
Page/Plan
Initials Sheet No.
DMS N/A a. tFor projects in the 20 coastal counties: Per NCAC 2H.1005, a 50 foot wide vegetative buffer is
provided adjacent to surface waters. For Redevelopment projects, a 30' wide vegetative
buffer adjacent surface waters is provided.
DMS N/A b. tFor HQW or ORW projects outside the 20 coastal counties: A 30 foot wide vegetative buffer is
provided adjacent to surface waters.
DMS C3.0 c. t For Phase II Post -Construction projects: All built upon area is located at least 30 feet
landward of all perennial and intermittent surface waters.
DMS N/A d. Deed restriction language as required on form SWU-101 shall be recorded as a restrictive
covenant. A copy of the recorded document shall be provided to DWQ within 30 days of
platting and prior to the sale of any lots.
DMS CO.0 e. Built upon area calculations are provided for the overall project and all lots.
DMS C0.0 f. Project conforms to low density requirements within the ORW AEC. (if applicable per
15A NCAC 2H .1007)
DMS N/A g. Side slopes of swales are no steeper than 3:1; or no steeper than 5:1 for curb outlet swales.
DMS N/A h. Longitudinal slope of swales is no greater than 5%; for non -curb outletprojects, calculations for
shear stress and velocity are provided if slope is greater than 5%.
DMS N/A i. At a minimum, swales are designed to carry the 10 year storm velocity at a non -erosive rate.
DMS N/A j. Swales discharging to wetlands are designed to flow into and through the wetlands at a non -
erosive velocity (for this flow requirement into wetlands, non -erosive is velocity < 2 ft/s).
DMS N/A k. Swale detail and permanent vegetation is specified on the plans.
DMS N/A 1. Swale detail provided on plans; includes grass type(s) for permanent vegetative cover.
DMS N/A m. Swales are located in recorded drainage easements.
DMS N/A n.tt Length of swale or vegetated area is at least 100 feet for each curb outlet.
DMS N/A o.tt The system takes into account the run-off at ultimate built -out potential from all surfaces
draining to the system (delineate drainage area for each swale).
DMS N/A p.tt Curb outlets direct flow to a swale or vegetated area.
t Projects in the Neuse, Tar -Pamlico, Catawba River basins, and Randleman Lake may require additional buffers.
tt Only complete these items for projects with curb outlets.
Form SW401-Low Density-Rev.3-2/10/09 Page 3 of 4

V. SWALE SYSTEM MAINTENANCE REQUIREMENTS
Mowing will be accomplished
as needed according
to the season.
Grass height will not exceed six inches at
any time; and grass will not be
mowed too close to
the ground or
"scalped".
2. Swales will be inspected monthly or after every runoff producing rainfall event for sediment build-up,
erosion, and trash accumulation.
Accumulated sediment and trash will be removed as necessary. Swales will be reseeded or sodded
following sediment removal.
4. Eroded areas
of the swales will be repaired and reseeded. Swales will
be revegetated as
needed and in a
timely manner based on the monthly inspections. Side slopes must be
maintained at the
permitted slope.
5. Catch basins, curb cuts, velocity reduction devices, and piping will be inspected monthly or after every
significant runoff producing rainfall event. Trash and debris will be cleared away from grates, curb cuts,
velocity reduction devices and piping.
6. Swales will not be altered, piped, or filled in without approval from NCDENR Division of Energy, Mineral
and Land Resources.
I acknowledge and agree by my signature below that I am responsible for the performance of the six
maintenance procedures listed above. I agree to notify DEMLR of any problems with the system or prior to any
changes to the system or responsible parry.
Print Name and Title:Jennifer Kirby
Address:16798 West Bernardo Drive, San Diego, CA 92127
Phone:[phone] Date: O E o
NOfe.' Tl�egffliy responsibleptf ry should not be a homeowners association unless more than 50% of the lots have been sold and a
resident of the subdivision has been named the president.
I J O (� ,� u4 c W 5 a Notary Public frror the State of 11i � � 1-mT h j q ,County of
.e n J& do hereby certify that 7¢,a r4 t b V personally appeared before me this _
day of 7, Pict V, 20�2 and acknowledge the due execution of/(he forgoing Swale maintenance requirements.
Witness my hand sand official seal,
Notary
SEAL My commission expires ` �` a y12 0 Z
Form SW401-Low Density-Rev.3-2/10/09 Page 4 of 4

% notary public or other officer completing this
certificate verifies only the identity of the individual
who signed the document to which this certificate
is attached, and not the truthfulness, accuracy, or
validity of that document.
State of cali ornia
County of k
Subscribed and sworn to (or affirmed) before me on this 7
day of /�K�, 202..), by J
proved to me on the basis of satisfactory evidence to be the
person(s) who appeared before me.
JOHN BACCUS ;
COMM. � 2223071
NOTARY PUBLIC CAUFORNIA fj
f VENTURACOUNTY
Comm. Exp. NOV. 24F 2021
�7
(Seal) Signature