9234_INSP_20170808

FACILITY COMPLIANCE INSPECTION REPORT
Division of Waste Management
Solid Waste Section

Page 1 of 3

UNIT TYPE:
Lined
MSWLF LCID YW Transfer X Compost SLAS COUNTY: WAKE
Closed
MSWLF HHW White
goods Incin T&P FIRM PERMIT NO.: 9234-TRANSFER-
CDLF Tire T&P /
Collection Tire
Monofill Industrial
Landfill DEMO SDTF FILE TYPE: COMPLIANCE

Date of Site Inspection: August 8, 2017 Date of Last Inspection: April 29, 2016

FACILITY NAME AND ADDRESS:
Wake Transfer Station
9220 Durant Road
Raleigh, NC 27616-3159

GPS COORDINATES: N: 35.8993 W: -78.5684

FACILITY CONTACT NAME AND PHONE NUMBER:
Travis Hitchcock, General Manager, 919-534-3724, [e-mail]
Nick Zdeb, Operations Supervisor, 919-534-3730, [e-mail]

FACILITY CONTACT ADDRESS:
Travis Hitchcock, General Manager
Waste Industries, Inc.
3741 Conquest Drive
Garner, NC 27529

PARTICIPANTS:
Liz Patterson, NCDEQ - Solid Waste Section
Dena Smith, Waste Industries

STATUS OF PERMIT:
Original Permit to Construct: June 9, 2003
Original Permit to Operate: October 23, 2003
Permit to Operate Amendment (ownership & name change): March 12, 2008
Permit to Operate Amendment (ownership & name change): July 19, 2012
Permit to Operate Amendment: November 15, 2012
The permit is due to expire on March 12, 2018

PURPOSE OF SITE VISIT:
Comprehensive Inspection

STATUS OF PAST NOTED VIOLATIONS:
None

OBSERVED VIOLATIONS:
None

The item(s) listed above were observed by Section staff and require action on behalf of the facility in order to come into or maintain compliance
with the Statutes, Rules, and/or other regulatory requirements applicable to this facility. Be advised that pursuant to N.C.G.S. 130A-22, an
administrative penalty of up to $15,000 per day may be assessed for each violation of the Solid Waste Laws, Regulations, Conditions of a Permit,
or Order under Article 9 of Chapter 130A of the N.C. General Statutes. Further, the facility and/or all responsible parties may also be subject to
enforcement actions including penalties, injunction from operation of a solid waste management facility or a solid waste collection service and any
such further relief as may be necessary to achieve compliance with the North Carolina Solid Waste Management Act and Rules.
FACILITY COMPLIANCE INSPECTION REPORT
Division of Waste Management
Solid Waste Section
Page 2 of 3

ADDITIONAL COMMENTS
1. This facility is permitted to receive C&D solid waste generated within the following counties: Chatham, Durham,
Franklin, Granville, Johnston, Nash, Orange, Vance and Wake and the municipalities contained within those
counties.

2. The facility operates Monday through Friday from 7:00 am to 4:00 pm.

3. The Permit and Operations Plan were reviewed. The permit is due to expire on March 12, 2018. An application
for permit review must be submitted to the Solid Waste Section by September 12, 2017.

4. An Emergency Management Plan is maintained onsite. Emergency contact information is posted in the scale
house. Emergency contacts are up-to-date.

5. Waste screening records were reviewed for January 4, 2017 through June 23, 2017. Waste screening records are
up-to-date and well organized. Personnel at the facility complete 1 or 2 recorded inspections per operating day.
The screening forms note any prohibited items observed and a description of the load. Good job!

6. Any prohibited items observed during unloading or a screening event are loaded back onto the truck they came
in on to be removed from the facility. Loads known to contain asbestos are not accepted at the facility. The
facility has charges a $25 fee for tires or pallets which has reduced the number of those banned items received.

7. Tires that are found at the facility are placed in a covered roll-off container until they can be properly disposed.

8. Waste that requires additional sorting for recycle will be sent to the Wake Material Reclamation Facility (9224T).
Waste that is not able to be separated out for recycling is transferred to Material Recovery C&D Landfill (9231)
or Red Rock Landfill (9228) for disposal.

9. A review of the tonnage records for July indicates that approximately 170 tons per day are currently being
accepted into the facility.

10. The following are facility certified personnel:
Dennis Braxton: Certified Transfer Station Operations Specialist, expires 11/20/2017
William Debnam: Certified Transfer Station Operations Specialist, expires 4/24/2018
Dena Smith: Certified Transfer Station Operations Specialist, expires 3/26/2017

11. An excavator with a grapple claw is used to sort material at the facility. Scrap metal, cardboard, wood, and wood
pallets are separated and placed into roll-off containers for recycling. All roll-off containers are covered when the
facility is not in operation.

12. Fire extinguishers were observed on each piece of equipment, near the fuel tank, in the scale house, and on the
wall at the edge of the tipping floor. All extinguishers were found to be fully charged and appeared to be properly
maintained.

13. Sediment control ponds are being well maintained.

FACILITY COMPLIANCE INSPECTION REPORT
Division of Waste Management
Solid Waste Section
Page 3 of 3

14. The tipping area was neat and clean with waste quickly sorted and loaded into outgoing trucks and containers.
Waste that accumulates outside the tipping floor barrier during loading of the transfer trailer is cleaned up after
each transfer truck is loaded. The tipping floor is concrete and is being well managed.

Tipping floor Transfer trailer loading area

15. Windblown litter was observed during this inspection along the fence line on the western side of the facility. At
the conclusion of each day of operation, all windblown material resulting from the operation shall be collected
and returned to the area.

Please contact me if you have any questions or concerns regarding this inspection report.

Phone: [phone](O) 919-805-6499(C)
[e-mail]

Liz Patterson
Environmental Senior Specialist
Regional Representative

Sent on: 8-29-2017 X Email Hand delivery US Mail Certified No. [ _]

Copies: Drew Hammonds, Eastern District Supervisor - Solid Waste Section
Jessica Montie, Environmental Program Consultant - Solid Waste Section