NCS01634_INSP_20221019

NORTH CARnLINAD_E Q��
o.n.mm.m m c.w.mm.m.i a.i�
FACILITY COMPLIANCE INSPECTION REPORT
Division of Waste Management
Solid Waste Section
UNIT TYPE:
Lined
LCID
YW
Transfer
Compost
SLAS
COUNTY: Rockin ham
g
MSWLF
PERMIT NO.: NCS-01634
Closed
HHW
White
Incin
T&P
FIRM
X
MSWLF
goods
FILE TYPE: COMPLIANCE
CDLF
TireT&P/
Tire
Industrial
DEMO
SDTF
Collection
Monofill
Landfill
Date of Site Inspection: 10/19/2022
FACILITY NAME AND ADDRESS:
Mr. Alexander Phillips
Tidy Services
2011 Cook Drive
Salem, VA 24153
GPS COORDINATES: N: NA
Date of Last Inspection:
FACILITY CONTACT INFORMATION:
Name: Steve Ritter
Address: Same as above
Telephone: [phone]
Email address: [e-mail]
PARTICIPANTS: Chester Cobb (DWM), Steve Ritter, and Mark
STATUS OF PERMIT: Pending EXPIRES:
PURPOSE OF SITE VISIT: Pre -operational
STATUS OF PAST NOTED VIOLATIONS:
NA
E: NA
OBSERVED VIOLATIONS:
1) The lettering for "Services" of the Firm Name did not meet the lettering requirement of 3 inches in
height. This is a violation of Rule 15A NCAC 13B .0835(a)(b). See Additional Comments.
The item(s) listed above were observed by Section staff and require action on behalf of the facility in order to come into or maintain compliance
with the Statutes, Rules, and/or other regulatory requirements applicable to this facility. Be advised that pursuant to N.C.G.S. 130A-22, an
administrative penalty of up to $15,000 per day may be assessed for each violation of the Solid Waste Laws, Regulations, Conditions of a Permit,
or Order under Article 9 of Chapter 130A of the N.C. General Statutes. Further, the facility and/or all responsible parties may also be subject to
enforcement actions including penalties, injunction from operation of a solid waste management facility or a solid waste collection service and
any such further relief as may be necessary to achieve compliance with the North Carolina Solid Waste Management Act and Rules.
Page 1 of 2

Oepartmenl o� Envimnmental0uali�
ADDITIONAL COMMENTS
1) Pumper vehicle(s) inspected:
FACILITY COMPLIANCE INSPECTION REPORT
Division of Waste Management
Solid Waste Section
TRUCK
LICENSE PLATE #
VIN #
TANK CAPACITY (gal)
i
UB57-608
3C7WRKBJ6NG275010
375 water / 900 waste
2) The required information of Firm name, town name, phone #, and permit # was on both sides of the
pumper vehicle. "Services" of the Firm name "Tidy Services" was around 2.5 inches. Outside of
"Services," each letter of the required information was three (3) inches or greater in height. The
lettering was distinguishable and not blocked from view. See pictures below.
3) The tank is made of aluminum and affixed to the frame of the truck as per 15A NCAC 13B .0835(a)(1).
4) The valves appeared to be in working order and closed as per 15A NCAC 13B .0835(a)(2). Caps present
on ports.
5) Access ports were closed and properly sealed as per 15A NCAC 13B .0835(a)(3).
6) No leaks noticed as per 15A NCAC 13B .0835(a).
7) Pumper vehicle did not pass inspection because the lettering for the Firm name did not meet the 3
inches in height requirement.
'
SALEM
' -
D �i
NCS - O� � J
IL i
i"
�40
�
-- •
_ y,_�_, •1 ��� 395 0,168
• NCS - 01534-
L■I
t
� _ --- - _ \
7„
.� ��• -Y - f.
L Y � w
1 I�I � •
IS
r
Picture of passenger side of pumper vehicle.
Please contact me if you have any questions or concerns regarding this inspection report.
Phone: [phone] .
Chester R. Cobb, Environmental Program Consultant
Division of Waste Management, NCDEQ
Regional Representative
Sent on: Email Hand delivery US Mail Certified No. L-j
Page 2 of 2