NCS01669_INSP_20230301

NORTH CARnLINAD_E Q��
o.n.mm.m m c.w.mm.m.i a.i�
FACILITY COMPLIANCE INSPECTION REPORT
Division of Waste Management
Solid Waste Section
UNIT TYPE:
Lined
LCID
YW
Transfer
Compost
SLAS
COUNTY: Wake
MSWLF
PERMIT NO.: NCS-01669
Closed
HHW
White
Incin
T&P
FIRM
X
MSWLF
goods
FILE TYPE: COMPLIANCE
CDLF
Tire T&P/
Tire
Industrial
DEMO
SDTF
Collection
Monofill
Landfill
Date of Site Inspection: 03/01/2023
FACILITY NAME AND ADDRESS:
Peacock Event Rentals
3917 Old US I Hwy
New Hill, NC 2 75 62
GPS COORDINATES: N: NA
Date of Last Inspection:
FACILITY CONTACT INFORMATION:
Name: Jason Davis
Address: Same as above
Telephone: [phone]
Email address: [e-mail]
PARTICIPANTS: Chester Cobb (DWM) and Jason Davis
STATUS OF PERMIT: Pending EXPIRES:
PURPOSE OF SITE VISIT: Pre -operational
STATUS OF PAST NOTED VIOLATIONS:
NA
OBSERVED VIOLATIONS:
NONE
E: NA
The item(s) listed above were observed by Section staff and require action on behalf of the facility in order to come into or maintain compliance
with the Statutes, Rules, and/or other regulatory requirements applicable to this facility. Be advised that pursuant to N.C.G.S. 130A-22, an
administrative penalty of up to $15,000 per day may be assessed for each violation of the Solid Waste Laws, Regulations, Conditions of a Permit,
or Order under Article 9 of Chapter 130A of the N.C. General Statutes. Further, the facility and/or all responsible parties may also be subject to
enforcement actions including penalties, injunction from operation of a solid waste management facility or a solid waste collection service and
any such further relief as may be necessary to achieve compliance with the North Carolina Solid Waste Management Act and Rules.
Page 1 of 2

Oepartmenl o� Envimnmental0uali�
ADDITIONAL COMMENTS
1) Pumper vehicle(s) inspected:
FACILITY COMPLIANCE INSPECTION REPORT
Division of Waste Management
Solid Waste Section
TRUCK
LICENSE PLATE #
VIN #
TANK CAPACITY (gal)
1
KC-6239
1FTWW32F1XEE89131
300
2) The required information of Firm name, town name, phone #, and permit # was on both sides of the
pumper vehicle. Each letter of the required information was greater than three (3) inches in height. The
lettering was distinguishable and not blocked from view. The lettering meets the requirements of 15A
NCAC 13B .0835(b). See pictures below.
3) The tank is made of metal and affixed to the frame of the truck as per 15A NCAC 13B .0835(a)(1).
4) The valves appeared to be in working order and closed as per 15A NCAC 13B .0835(a)(2). Caps present
on ports.
5) Access ports were closed and properly sealed as per 15A NCAC 13B .0835(a)(3).
6) No leaks noticed as per 15A NCAC 13B .0835(a).
7) Truck in compliance with the Septage Rules.
Please contact me if you have any questions or concerns regarding this inspection report.
Digitally signed by Chester Cobb
DN: cn=Chester Cobb, o=NC DEQ,
ou=Division of Waste Management,
email=[e-mail], c=US
Date: 2023.04.06 14:07:42-04'00' Phone: [phone]
Chester R. Cobb, Environmental Program Consultant
Division of Waste Management, NCDEQ
Regional Representative
Sent on: X Email Hand delivery US Mail Certified No. fj
Page 2 of 2