HomeMy WebLinkAbout8302TRANSFER1997_INSP_20211026FACILITY COMPLIANCE INSPECTION REPORT
Division of Waste Management
Solid Waste Section
Page 1 of 5
UNIT TYPE:
Lined MSWLF LCID YW Transfer X Compost SLAS COUNTY: Scotland
Closed MSWLF HHW White goods Incin T&P FIRM PERMIT NO.: 8302T-TRANSFER-1997
CDLF Tire T&P / Collection Tire Monofill Industrial Landfill DEMO SDTF FILE TYPE: COMPLIANCE
Date of Site Inspection: October 26, 2021 Date of Last Inspection: August 4, 2021
FACILITY NAME AND ADDRESS: Scotland County Transfer Station
10701 Patterson Road, Maxton, NC 28352 GPS COORDINATES: Lat: 34.72641° Long: -79.37884° FACILITY CONTACT NAME AND PHONE NUMBER: Bryant Higgins, SW Director 901-844-9206 bhiggins@scotlandcounty.org Bill Lash, Landfill Supervisor 910-352-3557 blash@scotlandcounty.org FACILITY CONTACT ADDRESS: Scotland County Annex 231 E. Cronly St.
P.O. Box 489, Laurinburg, NC 28353
PARTICIPANTS: David Powell, NC DEQ – Solid Waste Section Bill Lash, Scotland County Landfill Supervisor
STATUS OF PERMIT: Life of Site Permit to Operate Expires December 31, 2057
PURPOSE OF SITE VISIT: Comprehensive Inspection – Follow Up
STATUS OF PAST NOTED VIOLATIONS: 15A NCAC 13B .0405 (b) – RESOLVED 15A NCAC 13B .0405 (c) - RESOLVED OBSERVED VIOLATIONS: NA
The item(s) listed above were observed by Section staff and require action on behalf of the facility in order to come into or maintain compliance with the Statutes, Rules, and/or other regulatory requirements applicable to this facility. Be advised that pursuant to N.C.G.S. 130A-22, an administrative penalty of up to $15,000 per day may be assessed for each violation of the Solid Waste Laws, Regulations, Conditions of a Permit, or Order under Article 9 of Chapter 130A of the N.C. General Statutes. Further, the facility and/or all responsible parties may also be subject to enforcement actions including penalties, injunction from operation of a solid waste management facility or a solid waste collection service and any such further relief as may be necessary to achieve compliance with the North Carolina Solid Waste Management Act and Rules.
FACILITY COMPLIANCE INSPECTION REPORT
Division of Waste Management
Solid Waste Section
Page 2 of 5
ADDITIONAL COMMENTS
1. The leachate area has been cleaned up and a new berm installed for trailers to back onto. New leachate
collection bins are also available and being used in conjunction with 55-gallon drums. Drums will allow for any leak discovered along the trailer to have a collection bin as well. Good job. Stay diligent in inspecting the trailers for cracks/holes when being dropped off. All issues have been resolved at the Transfer Station. Thank
you and good job.
Leachate ponding area with new rock/soil.
New rock berm for trailer rear-ends to park upon.
FACILITY COMPLIANCE INSPECTION REPORT
Division of Waste Management
Solid Waste Section
Page 3 of 5
55-gallon drum being used in small leak in trailer.
2. The facility had essentially no windblown waste observed during the inspection. Around the facility was well maintained. Good job.
Side of Transfer Station, looks good.
FACILITY COMPLIANCE INSPECTION REPORT
Division of Waste Management
Solid Waste Section
Page 4 of 5
3. Tipping floor was in fair condition.
4. Trailer area below tipping floor was in a cleaner condition than previous visit, good job.
FACILITY COMPLIANCE INSPECTION REPORT
Division of Waste Management
Solid Waste Section
Page 5 of 5
5. MW-6 was repaired and had a new lock. Good job.
6. A Sampling Plan was submitted to the Section, approved, and satisfied, with no further action required per email dated September 27, 2021, from Mr. Williams Sugg with the Section.
Please contact me if you have any questions or concerns regarding this inspection report. _ ___________________________ Phone: 910-433-3350 _ David Powell Environmental Senior Specialist Regional Representative
Sent on: 11/4/2021 X Email Hand delivery US Mail Certified No. [ _]
Copies: Drew Hammonds, Eastern District Supervisor - Solid Waste Section Ming Chao, Permitting Engineer – Solid Waste Section William Sugg, Hydrogeologist – Solid Waste Section