5410_INSP_20201021

FACILITY COMPLIANCE INSPECTION REPORT
Division of Waste Management
Solid Waste Section

Page 1 of 6

UNIT TYPE:
Lined
MSWLF LCID X YW Transfer Compost SLAS COUNTY: LENOIR
Closed
MSWLF HHW White
goods Incin T&P FIRM PERMIT NO.: 5410-LCID-2016
CDLF Tire T&P /
Collection Tire
Monofill Industrial
Landfill DEMO SDTF FILE TYPE: COMPLIANCE

Date of Site Inspection: October 21, 2020

FACILITY NAME AND ADDRESS:
Everett’s Clearing & Grading, Inc.
Located near 4062 Aldridge Store Road, La Grange, NC 28551

GPS COORDINATES: N: 33.334912° W: -77.728749 °

FACILITY CONTACT NAME AND PHONE NUMBER:
Lynn Everette, Owner and Operator
Phone:[phone]
Email:[e-mail]

FACILITY CONTACT ADDRESS:
Lynn Everett,
Everett’s Clearing& Grading, Inc.
2402 Fred Everette Road
Kinston, NC 28504

PARTICIPANTS:
Liz Patterson, NCDEQ –Solid Waste Section

STATUS OF PERMIT:
Original Permit Approval to Construct and Operate: Issued November 29, 2016. Expires November 29, 2021,

PURPOSE OF SITE VISIT:
Partial Inspection

STATUS OF PAST NOTED VIOLATIONS:
NONE

FACILITY COMPLIANCE INSPECTION REPORT
Division of Waste Management
Solid Waste Section

Page 2 of 6

OBSERVED VIOLATIONS:
1. Per 15A NCAC 13B .0566 (2) states that “The facility shall only accept those solid wastes which it is
permitted to receive.”

Unacceptable waste streams were noted during the inspection. Treated lumber, engineered wood, electrical
junction box and any other unacceptable waste need to be removed and properly disposed of at a facility
permitted to accept the waste type. The waste needs to be disposed of at a permitted facility within 30 days of
receipt of this report. Documentation will be required to indicate that the waste has been disposed of
properly. Mail copies of receipts to Liz Patterson at Division of Waste Management, 127 Cardinal Drive Ext.,
Wilmington, NC 28405.

Electrical junction box, engineered wood, and treated lumber unacceptable wastes at time of inspection.

FACILITY COMPLIANCE INSPECTION REPORT
Division of Waste Management
Solid Waste Section

Page 3 of 6

Engineered wood, treated lumber on side slopes in as you enter the LCID.

2. Per NCAC 13B .0566 (11) States: “Solid waste shall not be disposed of in water.”

Waste was being disposed in standing water at the time of the inspection. Please remove and correct the slope so
storm water ca be managed without erosion. Be careful not to cause any water quality violations with runoff.

FACILITY COMPLIANCE INSPECTION REPORT
Division of Waste Management
Solid Waste Section

Page 4 of 6

3. Per Attachment 3, Section 11, of the LCID permit No. 5410-LCID-2016 states, “Excavation, grading and fill
material side slopes must not exceed a ratio of three horizontal feet to one vertical feet (3:1) as shown on the
drawings of the approved plan (DIN 27057) and according to Rule 15A NCAC 13B .0563(3)(j).”

Side slopes on several areas were greater than a 3:1 slope. Unacceptable waste needs to be removed. These
areas need additional cover which should be corrected during that process.

Steep side slopes when entering facility

4. Per Attachment 3, Section 17, of the LCID permit No. 5410-LCID-2016 states, “the facility must maintain a
supply of cover material adequate to cover the working face in case of an emergency or fire, at all times.

There was not sufficient cover onsite to cover all the active areas/phases of waste onsite.

The item(s) listed above were observed by Section staff and require action on behalf of the facility in order to come into or maintain compliance
with the Statutes, Rules, and/or other regulatory requirements applicable to this facility. Be advised that pursuant to N.C.G.S. 130A-22, an
administrative penalty of up to $15,000 per day may be assessed for each violation of the Solid Waste Laws, Regulations, Conditions of a Permit,
or Order under Article 9 of Chapter 130A of the N.C. General Statutes. Further, the facility and/or all responsible parties may also be subject to
enforcement actions including penalties, injunction from operation of a solid waste management facility or a solid waste collection service and any
such further relief as may be necessary to achieve compliance with the North Carolina Solid Waste Management Act and Rules.
FACILITY COMPLIANCE INSPECTION REPORT
Division of Waste Management
Solid Waste Section

Page 5 of 6

ADDITIONAL COMMENTS
1. The facility is a land clearing and inert debris (LCID) landfill.
2. The facility has signage posted at the entrance to the haul road. The facility is properly secured with a locked gate.
The facility is not open to the public.

3. The PTO expiration date is November 29, 2021. No later than May 29, 2021, the permittee must submit a request
to the Section for permit review and must submit updated facility and operational plans meeting the requirements
of Rules 15A NCAC 13B.0565 and .0566.
4. The facility is permitted to receive waste generated from any county in the State of North Carolina, but most
waste generated from the following counties – Lenoir, Wayne, Craven, Pitt, Green Duplin, Onslow, and Jones
Counties.
5. The facility is permitted to receive land clearing waste, yard trash, untreated and unpainted wood, uncontaminated
soil, concrete, and concrete block.
6. Per 15A NCAC 13B .0566(3), “Solid waste shall be restricted to the smallest area feasible and compacted as
densely as practical into cells.”
7. Stockpiled materials are being maintained in reasonably sized piles with adequate fire breaks.
8. When correcting the slope issue and adding cover, be sure not to encroach onto the required buffers.
9. Facility stockpiles concrete onsite for future use. Per G.S. 130A-309.5 (c) (1) Seventy-five percent (75%), by
weight or volume, of the recovered material stored at a facility at the beginning of a calendar year
commencing January 1, shall be removed from the facility through sale, use, or reuse by December 31 of
the same year.

FACILITY COMPLIANCE INSPECTION REPORT
Division of Waste Management
Solid Waste Section

Page 6 of 6

10. Digital pictures were taken during the inspection.
11. Corrective measures are necessary at this facility. Measures to bring the facility into compliance must be
completed within 30 days receipt of this report. The SWS will conduct a follow-up inspection in 30 days to
ensure issues noted in this inspection report have been addressed

Please contact me if you have any questions or concerns regarding this inspection report.

Phone: [phone](O)
[e-mail]
Liz Patterson
Environmental Senior Specialist
Regional Representative

Sent on: 11-5-2020 X Email Hand delivery US Mail Certified No. [ _]

Copies: Drew Hammonds, Eastern District Supervisor - Solid Waste Section
Jason Watkins, Field Operations Branch Head - Solid Waste Section
Jessica Montie, Environmental Program Consultant- Solid Waste Section
Amanda Freeman, Compliance Officer – Solid waste Section