NCS01062_INSP_20180712

FACILITY COMPLIANCE INSPECTION REPORT
Division of Waste Management
Solid Waste Section

Page 1 of 2

UNIT TYPE:
Lined MSWLF LCID YW Transfer Compost SLAS COUNTY: Stokes
Closed MSWLF HHW White goods Incin T&P FIRM X PERMIT NO.: NCS-01062
CDLF Tire T&P / Collection Tire Monofill Industrial Landfill DEMO SDTF FILE TYPE: COMPLIANCE

Date of Site Inspection: 7/12/2018 Date of Last Inspection: 8/7/2013
FACILITY NAME AND ADDRESS:
Hall Septic Tank Service 1715 Steele Road Sandy Ridge, NC 27046 FACILITY CONTACT NAME AND PHONE NUMBER:
Name: Alan K. Hall Telephone: [phone]
Email address: [e-mail] FACILITY CONTACT ADDRESS:
Same as above

PARTICIPANTS:
Troy Harrison, NC Solid Waste Section Jeffrey Bullard, NC Solid Waste Section
Alan Hall, Hall Septic Tank Service
STATUS OF PERMIT:
Active
PURPOSE OF SITE VISIT: New Pumper Vehicle
STATUS OF PAST NOTED VIOLATIONS: N/A

OBSERVED VIOLATIONS:
1. 15A NCAC 13B .0844 (b) states: “All permitted septage management firms shall display decals or lettering on each side of every pumper vehicle operated by the firm. The decals or lettering shall include the name, address (town name), phone number, and septage management firm permit number. All decals or lettering on the
pumper vehicle shall be no less than three inches in height and plainly visible. Identification shall be permanently attached (i.e., no removable signs).

Hall Septic Tank Service was in violation of 15A NCAC 13B .0844 (b) because on July 12, 2018 it was observed that a pumper vehicle had been placed into service with the permit number lettering less than 3” in
height.
On July 16, 2018, photographs were submitted to the Solid Waste Section indicating that the lettering had been
corrected to at least 3” in height.

The violation is resolved and no further action is necessary.
FACILITY COMPLIANCE INSPECTION REPORT
Division of Waste Management
Solid Waste Section

Page 2 of 2

ADDITIONAL COMMENTS
1. The inspection was conducted at the Asheville Regional Office, Swannanoa, NC. 2. The following firm truck was inspected:
Vehicle Identification Number (VIN) NC Tag Number Capacity (gallons)
1FZAC0BS09AAF8437 YA117621 2500
3. The tank appeared to be structurally sound and bolted to the frame.

4. Valves and access ports appeared to be secure. Caps were present on the access ports. 5. The truck was properly marked in accordance with the lettering requirements; except for the permit number, which
was less than 3 inches in height. This was corrected and a photograph submitted on 7/16/18 (see below). The vehicle had been placed in operation prior to the inspection.
6. No leaks were observed.
Please contact me if you have any questions or concerns regarding this inspection report.

_________________________________________ Phone: [phone]
Troy Harrison Environmental Senior Specialist Regional Representative
Sent on: 7/17/2018 X Email Hand delivery US Mail Certified No. [ _]

Copies: NC Solid Waste Section Files
The item(s) listed above were observed by Section staff and require action on behalf of the facility in order to come into or maintain compliance
with the Statutes, Rules, and/or other regulatory requirements applicable to this facility. Be advised that pursuant to N.C.G.S. 130A-22, an administrative penalty of up to $15,000 per day may be assessed for each violation of the Solid Waste Laws, Regulations, Conditions of a Permit,
or Order under Article 9 of Chapter 130A of the N.C. General Statutes. Further, the facility and/or all responsible parties may also be subject to enforcement actions including penalties, injunction from operation of a solid waste management facility or a solid waste collection service and any such further relief as may be necessary to achieve compliance with the North Carolina Solid Waste Management Act and Rules.