SLAS8303_Soil Report_20130111

NCDA&CS Agronomic Division Phone: [phone] Website: www.ncagr.gov/agronomi/ Report No.FY13-SL019843
Mehlich-3 Extraction
Completed: Received:Sampled:
Soil Report
Farm:
County:
Client:
Links to Helpful Information
Advisor:
Wagram, NC 28396
Raleigh, NC 27699
1646 Mail Service Ctr.
31147 Hillcreek Rd
Dale Jones
c/o NC Division of Solid Waste
Connie Wylie
83-03
Scotland
01/11/201301/04/201301/04/2013
Heavy Metals
ATTENTION: This report contains both routine soil test information as well as heavy metals data in a section labeled as Heavy Metals under soil test lab results. Using Mehlich 3 as a
soil test extractant, background levels of these metals typically seen in NC soils when analyzed are as follows: arsenic (As)- 4.5 ppm, cadmium (Cd)- 0.1 ppm, chromium (Cr)- 0.2 ppm,
lead (Pb)- 4.2 ppm, nickel (Ni)- 0.8 ppm, & selenium (Se)- 0.2 ppm (FY2005-2007). Although the above metals here are not believed to pose a concern for plant growth, continue to
monitor these and note where elevated above background levels become toxic to crops grown on a field. Note any lime and fertilizer recommendations. Where soil test phosphorus (P)
is very high (P-I > 100), crops will not respond to additional P applied. Jagathi Kamalakanthan 1/17/2013
Agronomist's Comments:
Lime History:
Sample ID: More
Information
Test Results [units - W/V in g/cm ; CEC and Na in meq/100 cm ; NO3-N in mg/dm ]: Soil Class:
Ca%NO3-NSS-IESPNaCu-IZn-AIZn-IMn-AI2Mn-AI1Mn-IS-IMg%K-IP-IpHAcBS%CECW/VHM%
2 -
1 -
Crop
Recommendations:Lime
BCuZnMnSMgK2OP2O5N
Mineral
Pine,M
Pine,M
0.0
0.0
1
100-150
100-150
0
0
$
25
0
0
71665.71.0825.31.290.66 26552944637
0
0
60
60
Note: 11
Note: 11 Note: $
294
(tons/acre)
333
0
0
76 5
Nutrients (lb/acre)
0.1
0.1Selenium,2.8Lead,0.2Chromium,0.2Nickel,0.1Cadmium,0.1Arsenic,Heavy Metals (parts per million):
- Steve Troxler, Commissioner of Agriculture
Thank you for using agronomic services to manage nutrients and safeguard environmental quality.
through a grant from the North Carolina Tobacco Trust Fund Commission.
Reprogramming of the laboratory-information-management system that makes this report possible is being funded
NCDA&CS Agronomic Division Phone: [phone] Website: www.ncagr.gov/agronomi/ Report No.FY13-SL019843
Page 2 of 2Dale Jones
Recommendations
Lime
If testing finds that soil pH is too low for the crop(s) indicated, a lime recommendation will be given in units of either
ton/acre or lb/1000 sq ft. For best results, mix the lime into the top 6 to 8 inches of soil several months before planting.
For no-till or established plantings where this is not possible, apply no more than 1 to 1.5 ton/acre (50 lb/1000 sq ft) at
one time, even if the report recommends more. You can apply the rest in similar increments every six months until the
full rate is applied. If MG is recommended and lime is needed, use dolomitric lime.
Fertilizer
Recommendations for field crops or other large areas are listed separately for each nutrient to be added (in units of
lb/acre unless otherwise specified). Recommendations for N (and sometimes for B) are based on research/field studies
for the crop being grown, not on soil test results. K-I and P-I values are based on test results and should be > 50. If they
are not, follow the fertilizer recommendations given. If Mg is needed and no lime is recommended, 0-0-22 (11.5% Mg) is
an excellent source; 175 to 250 lb per acre alone or in a fertilizer blend will usually satisfy crop needs, SS-I levels appear
only on reports for greenhouse soil or problem samples.
Farmers and other commercial producers should pay special attention to micronutrient levels. If $, pH$, $pH, C or Z
notations appear on the soil report, refer to . In general, homeowners do not
need to be concerned about micronutrients. Various crop notes also address lime fertilizer needs; visit
Recommendations for small areas, such as home lawns/gardens, are listed in units of lb/1000 ft . If you cannot find
the exact fertilizer grade recommended on the report, visit to find information
that may help you choose a comparable alternate. For more information, read
.
Test Results
The first seven values [soil class, HM%, W/V, CEC, BS%, Ac and pH] describe the soil and its degree of acidity. The
remaining 16 [P-I, K-I, Ca%, Mg%, Mn-I, Mn-AI1, Mn-AI2, Zn-I, Zn-AI, Cu-I, S-I, SS-I, Na, ESP, SS-I, NO3-N (not
routinely available)] indicate levels of plant nutrients or other fertility measurement. Visit
for more information.
Report Abbreviations
Ac exchangeable acidity
B boron
BS% % CEC occupied by basic cations
Ca%% CEC occupied by calcium
CEC cation exchange capacity
Cu-I copper index
ESP exchangeable sodium percent
HM%percent humic matter
K-I potassium index
K2O potash
Mg%% CEC occupied by magnesium
MIN mineral soil class
Mn manganese
Mn-Al1 Mn-availability index for crop 1
Mn-AI2 Mn-availability index for crop 2
Mn-I manganese index
M-O mineral-organic soil class
N nitrogen
Na sodium
NO3-N nitrate nitrogen
ORG organic soil class
pH current soil pH
P-I phosphorus index
P2O5 phosphate
S-I sulfur index
SS-I soluble salt index
W/V weight per volume
Zn-AI zinc availability index
Zn-I zinc index
Understanding the Soil Report: explanation of measurements, abbreviations and units
$Note: Secondary Nutrients and Micronutrients
www.ncagr.gov/agronomi/obpart4.htm#fs
A Homeowner's Guide to Fertilizer.
www.ncagr.gov/agronomi/uyrst.htm
ncagr.gov/agronomi/pubs.htm.