HomeMy WebLinkAboutNCC190145_NOT Closeout Documents_20210302SEDIMENTATION INSPECTION REPORT
Iredell County Planning & Development
Erosion Control Section
349 North Center Street/P.O. Box 788
Statesville, NC 28687
Location: Mooresville Project: Crossfit 77 Tuf Field Installation
Person financially responsible: Medallion Athletic Products Inc., Lance
Rosenberger
Address:150 River Park Road
Mooresville, NC 28117
Weather and soil conditions: Sunny, 70's, Workable
Is site currently under Notice of Violation? ❑Yes ❑No
Structural BMPs
Construction Entrance
Silt Fence/Outlet
Sediment Basin/Trap
Diversion Berm/Ditch
Permanent Ditches/Checks
Inlet/Outlet Protection
Other:
Inspection
Type
Initial
❑
Routine
❑
Follow-up
❑
Final
Enforcement
❑
Project #: MVLLE-2019-082
River basin: Catawba
Project location: Raceway Drive
Photographic Documentation: ❑Yes ®No
❑Prints ❑Slides ❑Video ❑Digital
Functioning Needs Maintenance Not Installed
❑
❑
❑
❑
❑
❑
❑
❑
❑
❑
❑
❑
Not Applicable
El
If structural BMPs are not functioning properly, note location and corrective action on reverse side of this form
Vegetative Controls
Adequate
Not Adequate
Absent
Not Applicable
Stream Buffers
❑
❑
❑
Temporary Stabilization
❑
❑
❑
Permanent Stabilization
®
❑
❑
❑
If vegetation is not adequate, note location and corrective action on reverse side of this form
Erosion/Sedimentation
No Yes -Minor Yes -Moderate Yes -Severe
Is there ON -SITE erosion occurring?
®
❑
❑
Is there OFF -SITE sediment loss?
®
❑
❑
Did sediment reach a STREAM?
®
❑
❑
If any of the above are "Yes",
note the location and corrective action on
reverse side of this form
Is site in compliance with S.P.C.A. and rules, and ICLDC? If Not Compliant, check
violations on second page.
Compliant Needs Maintenance Not Compliant
This site is... ❑ ❑ ❑
Sediment Inspection Report Continued
Violations:
❑a. No approved plan, G.S. 113A-57(4) and 15A NCAC 04B .0107(c) ❑g. Inadequate buffer zone, G.S. 113A-57(1) and
and Section 8.12 of the ICLDC Section 10.18.2 of the ICLDC
❑b. Failure to follow approved plan, G.S. 113A-57(5) and Section ❑h. Graded slopes and fills too steep, G.S. 113A-
8.12 of the ICLDC 57(2) or 15A NCAC 04B .0124(d) Section 10.18.3
of the ICLDC
❑c. Failure to submit revised plan, G.S. 113A-54.1(b) and ❑i. Unprotected exposed slopes, G.S. 113A-57(2)
15A NCAC 04B .0118(a) and Section 9.6.10 of the ICLDC and Section 10.18.3 of the ICLDC
❑d. Failure to provide adequate groundcover, G.S. 113A-57(3) and ❑j. Failure to install and/or maintain erosion
15A NCAC 04B .0107(b) or 15A NCAC 04B .0124(e) and Section control measures, 15A NCAC 04B .0113 and
10.18.5 of the ICLDC Section 10.18.11 of the ICLDC
❑e. Insufficient measures to retain sediment on site, G.S. 113A-57(3) ❑k .Failure to self -inspect G.S. 113A-54.1(e) and
and Section 10.18.11 of the ICLDC 15A N.C.A.C. 4B.0131 and Section 9.6.13 of the
ICLDC
❑f. Failure to take all reasonable measures, 15A NCAC 04B .0105 ❑I. Other (describe)
and Section 10.18.11 of the ICLDC
Potential NPDES Permit Violation? ❑Yes ®No ❑Not Applicable Describe:
Has sedimentation damage occurred since last inspection? ❑Yes ®No If yes, where?
(check all that apply)
❑Lake/natural watercourse on the tract ❑Lake/natural watercourse off the tract
❑Other property ❑Roadway ❑Storm sewer
Description:
Degree of damage: ❑Slight ❑Moderate ❑Severe
Contact made with: No One Inspection report sent to person financially responsible on this date:
Comments / Corrective Actions Needed: Permanent ground cover sufficient to restrain
erosion has been established. No additional self -monitoring or self -inspections are required.
Project is released. Termination of coverage under the NPDES General Stormwater Permit for
Construction Activities should be requested by the permittee via a Notice of Termination.
Reported by: R. Moore
Date of inspection: 6/3/19
cc:
Phone: 704-832-2352
Time arriving on site: 9:35 am
Others present:
Time leaving site: 9:40 am
All erosion and sediment control measures must meet the standards per approved Erosion Control Plan and the North Carolina Erosion and
Sediment Control Planning and Design Manual