HomeMy WebLinkAboutAQ_F_0700150_20170707_CMPL_CompRpt Semi-Annual Report
National Emission Standards for Hazardous Air Pollutants:
Stationary Reciprocating Internal Combustion Engines
40 CFR Part 63, Subpart ZZZZ
Note: The information to be provided in the Notification of Compliance Status Report will vary depending on the engine type.
Affected sources should refer to 40 CFR Part 63,Subpart ZZZZ for engine-specific compliance requirements. [40CFR63.6650]
SECTION L• COMPANY NAME AND ADDRESS
Facility Name
Carolina Telephone and Telegraph Company LLC d/b/a CenturyLink
Street Address
135 West 2n Street
City State ZIP Code
Washington NC 27889
SECTION II: CERTIFICATION
I, as the responsible official of the above-mentioned facility, certify the information contained in this report is accurate and complete
to the best of my knowledge.
Name of Responsible Official Title Date(mm/dd/yyyy)
(Print or Type
Bob Harding MGR,Environmental Health and 07/07/2017
Safety
Signature of Responsible Official
Note: Responsible official is defined under§63.2 as one of the following:a president, vice-president,secretary, or treasurer
of the company that owns the plant;the owner of the plant;the plant engineer or supervisor;a government official if the
plant is owned by the Federal, State, city, or county government;or a ranking military officer if the plant is located on a
military installation.
SECTION III: REPORTING PERIOD
Check the one that applies and fill in the applicable calendar year(CY):
X ls`half CY2017 (January I —June 30) Due no later than July 3lst
2nd half CY20 (July 1—December 31) Due no later than January 31"
SECTION IV: DETERMINATION OF REPORTING CONTENTS FOR SEMIANNUAL REPORT
Check the following box(es)that apply to your facility during this reporting period.
X There were no deviations from any emission or operating limitations that apply to this facility during this reporting period.
❑ There were no periods during which the continuous monitoring system(CMS),including CEMS and CPMS,was out-of-
control during the reporting period.
Fill out the tables noted below, as applicable,to your facility during this reporting period. Print out only the completed, applicable
table(s),and submit this page and the completed tables,if any,to the appropriate reporting agency.
X Non-continuous monitoring system:Fill out Table I if there were deviations from any emission or operating limitations
(emission limit,operating limit,opacity limit),work practice standards,or operation and maintenance requirements during the
reporting period using a non-continuous monitoring system.
Continuous monitoring system:Fill out Table 2 if there were deviations from any emission or operating limitation(emission
limit,operating limit,opacity limit,and visible emission limit)during the reporting period using a continuous monitoring
system(CMS)including CEMS and CPMS during the reporting period. (CEMS: continuous emissions monitoring system;
CPMS: continuous parameter monitoring system)
TABLE 1: DEVIATIONS FROM NON-CONTINUOUS MONITORING SYSTEM
Malfunction means any sudden,infrequent, and not reasonably preventable failure of air pollution control equipment,process equipment,or a process to operate in a normal or
usual manner which causes,or has the potential to cause,the emission limitations in an applicable standard to be exceeded.Failures that are caused in part by poor maintenance or
careless operation are not malfunctions.
Deviation means any instance in which an affected source subject to this subpart,or an owner or operator of such a source: (1)Fails to meet any requirement or obligation
established by this subpart,including but not limited to any emission limitation or operating limitation;(2)Fails to meet any term or condition that is adopted to implement an
applicable requirement in this subpart and that is included in the operating permit for any affected source required to obtain such a permit;or(3)Fails to meet any emission
limitation or operating limitation in this subpart during malfunction,regardless of whether or not such failure is permitted by this subpart. (4)Fails to satisfy the general duty to
minimize emissions established by§ 63.6(e)(1)(i).
Place an"X"in the
applicable category Malfunctions only Deviations only
Total operating
time of the RICE
Event Event Event Description of when deviation Cause of the deviation(include
Number Date Malfunction Deviation I Duration Type occurred unknown cause,if applicable) Description of the corrective action taken
Emission standards apply during shutdown. Startup must be kept to no more than 30 minutes and emission standards do not apply during this time.
TABLE 2: DEVIATIONS FROM CONTINUOUS MONITORING SYSTEM(CMS)(Fill out 1 Table per each RICE source)
Deviations can be from any emission limitation(emission limit,operating limit,opacity limit,and visible emission limit)during the reporting period using a continuous monitoring
system(CMS)including CEMS and CPMS during the reporting period. (CEMS: continuous emissions monitoring system;CPMS: continuous parameter monitoring system)
Total operating time during this reporting period:
Description of the stationary RICE:
Type(CEMS/CPMS)and description of the CMS:
Description of any changes in the processes or controls since the last reporting period:
Date of the last monitoring system certification or audit(40CFR63.6650(e)(11):
Mark with an"X"when the deviation
occurred Mark with an"X"the cause of the deviation
Parameter
Malfunction Other**** or pollutant
Start In- CMS Control Known monitored
Event Date& End Date Event Mal- operative out of equip. Process causes Unknown (CO or Description of the corrective
Number Time & Time Duration function CMS** control*** Other problems problems (explain) causes CH2O) action taken
Example calculations: malfunction(hrs)=total hrs malfunction Total the hours of each event and list below
occurred during reporting period
Total duration of each deviation type and
occurrence scenario, in hours
Example calculations: %malfunction= (total hrs malfunction %= (total hrs each event/total hrs
occurred /total hrs operated)*100 operated) *100
Percent of the total source
operating time per %
deviation
Notes:
** Inoperative Monitoring System: except for zero(low-level)and high-level checks
*** A CMS is out of control if. (A)The zero (low-level),mid-level(if applicable),or high-level calibration drift(CD)exceeds two times the applicable CD specification in the
applicable performance specification or in the relevant standard;or(B)The CMS fails a performance test audit(e.g., cylinder gas audit),relative accuracy audit,relative
accuracy test audit,or linearity test audit;or(C)The COMS CD exceeds two times the limit in the applicable performance specification in the relevant standard.
**** Explanations for"other"deviations or malfunctions need to be provided in an attachment.
Emission standards apply during shutdown. Startup must be kept to no more than 30 minutes and emission standards do not apply during this time.
Semi-Annual Report
National Emission Standards for Hazardous Air Pollutants:
Stationary Reciprocating Internal Combustion Engines
40 CFR Part 63, Subpart ZZZZ
Note: The information to be provided in the Notification of Compliance Status Report will vary depending on the engine type.
Affected sources should refer to 40 CFR Part 63,Subpart ZZZZ for engine-specific compliance requirements. [40CFR63.6650]
SECTION L• COMPANY NAME AND ADDRESS
Facility Name
Carolina Telephone and Telegraph Company LLC d/b/a CenturyLink
Street Address
135 West 2n Street
City State ZIP Code
Washington NC 27889
SECTION II: CERTIFICATION
I, as the responsible official of the above-mentioned facility, certify the information contained in this report is accurate and complete
to the best of my knowledge.
Name of Responsible Official Title Date(mm/dd/yyyy)
(Print or Type
Bob Harding MGR,Environmental Health and 07/07/2017
Safety
Signature of Responsible Official
Note: Responsible official is defined under§63.2 as one of the following:a president, vice-president,secretary, or treasurer
of the company that owns the plant;the owner of the plant;the plant engineer or supervisor;a government official if the
plant is owned by the Federal, State, city, or county government;or a ranking military officer if the plant is located on a
military installation.
SECTION III: REPORTING PERIOD
Check the one that applies and fill in the applicable calendar year(CY):
X ls`half CY2017 (January I —June 30) Due no later than July 3lst
2nd half CY20 (July 1—December 31) Due no later than January 31"
SECTION IV: DETERMINATION OF REPORTING CONTENTS FOR SEMIANNUAL REPORT
Check the following box(es)that apply to your facility during this reporting period.
X There were no deviations from any emission or operating limitations that apply to this facility during this reporting period.
❑ There were no periods during which the continuous monitoring system(CMS),including CEMS and CPMS,was out-of-
control during the reporting period.
Fill out the tables noted below, as applicable,to your facility during this reporting period. Print out only the completed, applicable
table(s),and submit this page and the completed tables,if any,to the appropriate reporting agency.
X Non-continuous monitoring system:Fill out Table I if there were deviations from any emission or operating limitations
(emission limit,operating limit,opacity limit),work practice standards,or operation and maintenance requirements during the
reporting period using a non-continuous monitoring system.
Continuous monitoring system:Fill out Table 2 if there were deviations from any emission or operating limitation(emission
limit,operating limit,opacity limit,and visible emission limit)during the reporting period using a continuous monitoring
system(CMS)including CEMS and CPMS during the reporting period. (CEMS: continuous emissions monitoring system;
CPMS: continuous parameter monitoring system)
TABLE 1: DEVIATIONS FROM NON-CONTINUOUS MONITORING SYSTEM
Malfunction means any sudden,infrequent, and not reasonably preventable failure of air pollution control equipment,process equipment,or a process to operate in a normal or
usual manner which causes,or has the potential to cause,the emission limitations in an applicable standard to be exceeded.Failures that are caused in part by poor maintenance or
careless operation are not malfunctions.
Deviation means any instance in which an affected source subject to this subpart,or an owner or operator of such a source: (1)Fails to meet any requirement or obligation
established by this subpart,including but not limited to any emission limitation or operating limitation;(2)Fails to meet any term or condition that is adopted to implement an
applicable requirement in this subpart and that is included in the operating permit for any affected source required to obtain such a permit;or(3)Fails to meet any emission
limitation or operating limitation in this subpart during malfunction,regardless of whether or not such failure is permitted by this subpart. (4)Fails to satisfy the general duty to
minimize emissions established by§ 63.6(e)(1)(i).
Place an"X"in the
applicable category Malfunctions only Deviations only
Total operating
time of the RICE
Event Event Event Description of when deviation Cause of the deviation(include
Number Date Malfunction Deviation I Duration Type occurred unknown cause,if applicable) Description of the corrective action taken
Emission standards apply during shutdown. Startup must be kept to no more than 30 minutes and emission standards do not apply during this time.
TABLE 2: DEVIATIONS FROM CONTINUOUS MONITORING SYSTEM(CMS)(Fill out 1 Table per each RICE source)
Deviations can be from any emission limitation(emission limit,operating limit,opacity limit,and visible emission limit)during the reporting period using a continuous monitoring
system(CMS)including CEMS and CPMS during the reporting period. (CEMS: continuous emissions monitoring system;CPMS: continuous parameter monitoring system)
Total operating time during this reporting period:
Description of the stationary RICE:
Type(CEMS/CPMS)and description of the CMS:
Description of any changes in the processes or controls since the last reporting period:
Date of the last monitoring system certification or audit(40CFR63.6650(e)(11):
Mark with an"X"when the deviation
occurred Mark with an"X"the cause of the deviation
Parameter
Malfunction Other**** or pollutant
Start In- CMS Control Known monitored
Event Date& End Date Event Mal- operative out of equip. Process causes Unknown (CO or Description of the corrective
Number Time & Time Duration function CMS** control*** Other problems problems (explain) causes CH2O) action taken
Example calculations: malfunction(hrs)=total hrs malfunction Total the hours of each event and list below
occurred during reporting period
Total duration of each deviation type and
occurrence scenario, in hours
Example calculations: %malfunction= (total hrs malfunction %= (total hrs each event/total hrs
occurred /total hrs operated)*100 operated) *100
Percent of the total source
operating time per %
deviation
Notes:
** Inoperative Monitoring System: except for zero(low-level)and high-level checks
*** A CMS is out of control if. (A)The zero (low-level),mid-level(if applicable),or high-level calibration drift(CD)exceeds two times the applicable CD specification in the
applicable performance specification or in the relevant standard;or(B)The CMS fails a performance test audit(e.g., cylinder gas audit),relative accuracy audit,relative
accuracy test audit,or linearity test audit;or(C)The COMS CD exceeds two times the limit in the applicable performance specification in the relevant standard.
**** Explanations for"other"deviations or malfunctions need to be provided in an attachment.
Emission standards apply during shutdown. Startup must be kept to no more than 30 minutes and emission standards do not apply during this time.